User's Manual

3
End Product Labeling
This transmitter module is authorized only for use in
device where the antenna may be installed such
that 20cm may be maintained between the antenna
and users. The final end product must be labeled in
a visible area with the following: "Contains FCC ID:
WL6-TA1BC30TA1”
Information for the OEMs and Integrators
The following statement must be included with all
versions of this document supplied to an
OEM or integrator, but should not be distributed to
the end user.
1) This device is intended for OEM integrators only.
2) Please see the full Grant of Equipment document
for other restrictions.
This radio transmitter FCC ID: WL6-TA1BC30TA1
has been approved by FCC to operate with the
antenna types listed below with the maximum
permissible gain and required antenna impedance
for each antenna type indicated. Antenna types not
included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly
prohibited for use with this device.