Installation Guide

Assembly Instructions for BF01-05

NOTE: WRAP AT LEAST 3 LAYERS OF TEFLON TAPE ON ALL THREADED CONNECTIONS

1. Shut off the water supply valves before installation.

2. From the top , insert the valve bodies into the holes into on the sink, with hot on

the left and the cold on the right. (NOTE: THE O-RING ON THE BROACHES

ARE BLUE FOR COLD AND RED FOR HOT).

3. From undermeath, thread the mounting nuts onto the threaded shanks and

tighten tight.

4. Connect the supply lines (not included) to the threaded shanks.

5. Install handles. After installation in completed, turn on the water supply valves

and allow both hot and cold water to run at least on minute each. While water

is running, check for leaks, especially at hook-ups to supply lines. Tightening

nuts slightly will stop any minor leaks.

Assembly Instructions for Handles

Lever Handles:

1. Be sure that the broach screws are tightened before installing the lever handles.

2. Install the lever handles on the broaches and tighten the set screws using the allen

wrench provided.

Cross Handles:

1. Remove the screws from the top of the broaches.

2. Remove the insert caps from the cross handles.

3. Put the cross handles on the broaches and then tighten the screws. Insert the caps on

the cross handles.

Broach

Screw

Set

Screw

Allen

Wrench

Red O-Ring

Blue O-Ring

Cold Valve Body

Hot Valve Body

Mounting Nut

Cone Washer

Friction Ring

Supply Line Nut

Elizabethan

Classics

Rev.D

NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER

CAUTION: DO NOT OVER TIGHTEN NUTS - THIS CAN LEAD TO STRIPPING

OR CRACKING AND WILL VOID YOUR WARRANTY.

AND SCREWS