Installation Guide

Assembly Instructions for CS01-05
NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS
SHUT OFF THE WATER SUPPLY VALVES UNDER THE SINK. Cover the sink drain so that
no small parts are lost down it. Remove your old faucet. Caution: Do not damage your old water
supply lines. Clean the surface of the sink in preparation for installing the new faucet.
FAUCET INSTALLATION:
1. Place the plastic plate under the deck plate , then install the faucet in position on the sink.
Thread the mounting nuts onto the threaded shanks of the faucet, and tighten.
2. Connect the supply lines to the threaded shanks. Tighten brass supply line securely.
CAUTION-OVERTIGHTENING CAN STRIP OR OVER STRESS THERADS.
3. Install handles.
POP-UP INSTALLATION:
1. Unscrew seat and top gasket from pop-up assembly.
2. Slip drain through the drain opening and screw seat and top gasket onto the drain body.
3.Drop stopper into place. Remove pivot nut and insert pivot opening. Making sure the
pivot rod engages the stopper properly.
4.Remove spring clip from pivot rod and slide pivot nut pivot rod and thread onto pivot rod
opening. Tighten firmly, being careful not to overtighten.
5. With lift rod in positing on the faucet, insert the lift rod through the lift rod strap and secure
with the set screw.
6. Guide the pivot rod through one the holes on the lift rod strap and secure it with the spring
clip, then adjust the height of the lift rod by reseting the set screw.
AFTER INSTALLATIONS IS COMPLETED, remove the aerator. Turn on the water supply
valves and allow both hot and cold water to run at least one minute each. While water is
running, check for leaks, especially at hook-ups to supply lines. Tightening nuts slightly will
stop any minor leaks.
Assembly Instructions for Handles
Lever Handles:
1. Be sure that the broach screws are tightened installing the lever handles.
2. Install the lever handles on the broaches and tighten the set screws using the allen
wrench provided.
before
Cross Handles:
1. Remove the screws from the top of the broaches.
2. Remove the insert caps from the cross handles.
3. Put the cross handles on the broaches and then tighten the screws. Insert the caps on the
cross handles.
Broach
Broach
Screw
Set
Screw
Allen
Wrench
Deck Plate
Aerator
Stopper
Seat
Top Gasket
Washer
Bottom
Gasket
Mounting Nut
Pivot Rod Opening
Drain Body
Lift Rod
Set Screw
Lift Rod
Strap
Plastic Plate
Mounting Nut
Cone Washer
Friction Ring
Brass Supply
Line Nut
Spring Clip
Pivot Nut
Rev.D
Elizabethan
Classics
R
NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER
CAUTION: DO NOT OVER TIGHTEN NUTS AND SCREWS - THIS CAN LEAD TO
STRIPPING OR CRACKING AND WILL VOID YOUR WARRANTY.