Installation Guide

Assembly Instructions for ETS10-12
NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS
Elizabethan
Classics
R
1.Shut off the main water supply valves before installation.
2.Thread the Brass Nipple into wall stub, the nipple should extend 3/8 to 1 " from the front
of the finished wall.
3.Remove the Eccentric Shanks from faucet and keep escutcheons on shanks.
4.Thread Eccentric Shanks onto each cold and hot Brass Nipple. Ensure each escutcheon
is snug against the finished wall.
5.
6.
7.
8.Thread the Riser Connector onto faucet.
9.Thread the Riser onto 90 degree elbow. Slide brace connector onto riser. If desired,
slide the shower cradle onto riser. Note: A wall bracket holder for the hand held shower
is also provided.
10.Slide the Riser Nut onto Riser and install the Cone Washer at end of Riser. Insert the
Riser into the Align showerhead toward the front. Tighten the Riser Nut onto
11.Measure the distance from Brace Connector to the wall. Cut the unthreaded end of Brace.
Move the Brace Connector to the location which is approximate 11-1/2 below the
90 degree elbow to hide the connecting seam on Riser. Fix the Brace Connector by
Set Screw.Insert the unthreaded end into Brace Connector and install the Brace to
finished wall by Anchor Bolts.
12.Move the Shower Cradle up to proper position and fix it by set screw.
13.Thread the Shower Connector into faucet. Insert washer (A) into one hose end which
has a white check valve in it. Thread this end onto Shower Connector. Insert Washer (B)
into the other end of hose. Thread the Hand Shower to the hose.
14.Attach Wall Bracket to the wall by Anchor Bolts. Note : Ensure the set screw on
Wall Bracket is toward right
" /2
Align and level Eccentric Shanks with a 10mm Allen wrench. Ensure the center distance
of Coupling Nuts is 3-1/2".
Insert one Rubber Washer into each cold and hot Coupling Nut.
Insert the faucet into each cold and hot Coupling Nut. Partially thread the Coupling Nuts
onto faucet until tight.
L-riser. L-riser.
"
Assembly Instructions for Handles
Lever Handles:
1. Be sure that the broach screws are tightened installing the lever handles.
2. Install the lever handles on the broaches and tighten the set screws using the allen
wrench provided.
before
Cross Handles:
1. Remove the screws from the top of the broaches.
2. Remove the insert caps from the cross handles.
3. Put the cross handles on the broaches and then tighten the screws. Insert the caps on
the cross handles.
Broach
Broach
Screw
Set
Screw
Allen
Wrench
Rev.B
90 degree elbow
Finished Wall
Anchor Bolt
Brace
Set Screw
Brace Connector
Hand Shower
Washer (B)
Set Screw
Wall Bracket
Anchor Bolt
Riser Connector
Riser Nut
Cone Washer
Brass Nipple
Escutcheon
Eccentric Shank
Rubber Washer
Coupling Nut
Faucet
Washer (A)
Hose
L-Riser
NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER
Riser
CAUTION: DO NOT OVER TIGHTEN NUTS - THIS CAN LEAD
TO STRIPPING OR CRACKING AND WILL VOID YOUR
WARRANTY.
AND SCREWS