Installation Guide

Assembly Instructions for 3V3LSA

NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS

1. Shut off the water supply valves before installation.

2. According to your requirement, connect the riser or swivel arm connector kit to the faucet body.

3. Attach the diverter lever onto diverter valve and tighten the diverter screw.

3. Install handles. After installation is completed. Turn on the water supply valves and allow both hot

and cold water to run at least one minute each. While water is running. Check for leaks,

especially at hook-ups to supply lines. Tightening nuts slightly will stop any minor leaks.

Diverter lever

Diverter screw

Lever Handles:

1. Be sure that the broach screws are tightened installing the lever handles.

2. Install the lever handles on the broaches and tighten the set screws using the allen

wrench provided.

before

Cross Handles:

1. Remove the screws from the top of the broaches.

2. Remove the insert caps from the cross handles.

3. Put the cross handles on the broaches and then tighten the screws. Insert the caps on the

cross handles.

Broach

Screw

Set

Screw

Allen

Wrench

Assembly Instructions for Handles

Rev.D

Elizabethan

Classics

NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER

CAUTION: DO NOT OVER TIGHTEN NUTS AND SCREWS - THIS CAN LEAD TO

STRIPPING OR CRACKING AND WILL VOID YOUR WARRANTY.

RM11-15

PAGE 1
R Elizabethan Classics RM11-15 Assembly Instructions for 3V3LSA CAUTION: DO NOT OVER TIGHTEN NUTS AND SCREWS - THIS CAN LEAD TO STRIPPING OR CRACKING AND WILL VOID YOUR WARRANTY. NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER NOT E : US E TE F LO N TAP E ON AL L TH RE ADE D CO N N E CT I O N S 1. Shut off the water supply valves before installation. 2. According to your requirement, connect the riser or swivel arm connector kit to the faucet body. 3.
PAGE 2
R Elizabethan Classics Coupling Nut 90 degree elbow Rubber Washer Assembly Instructions for 6RMN Faucet Supply Shank CAUTION: DO NOT OVER TIGHTEN NUTS - THIS CAN LEAD TO STRIPPING OR CRACKING AND WILL VOID YOUR WARRANTY. NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS NOTE : REQUIRE ECSSL STRAIGHT BATH SUPPLY LINES WHICH INCLUDE SUPPLY LINE NUTS, FRICTION RINGS, AND CONE WASHERS. 1. Shut off the main water supply valves before installation.