Installation Instructions

755401-100
3
INSTALLATION INSTRUCTIONS
Photo 1
Photo 2
Photo 4
Photo 3
Photo 5
To ensure that you have received the proper heater designed to operate specifically with your bathtub, locate the bathtub model number
within the approved list located on the heater or at www.eljer.com/heaterindex.htm. If you cannot locate the specific bathtub model
number, do not install the heater assembly until the proper heater is received.
1. The Eljer heater can be installed either before or after
bathtub installation.
5. Insert the Eljer heater in the open space on the piping and
connect the couplings on the heater to the whirlpool piping
(photo # 4).
6. Tighten the couplings with the channel locks (photo #5).
7. Fill the tub with water and check for leaks.
8. Install heater ground per Figure 3 and plug the Eljer heater's
power cord into the dedicated 15 amp. GFCI outlet.
9. Start the pump and confirm that there are no leaks.
10. Turn the pump on and look to see if the light on the Eljer heater
is lit. This indicates that the heater is operating. If not check the
electrical connections at the outlet.
2. Identify the location of the inline heater blank. It
should be near the pump as shown in photo #1.
3. Using channel locks, loosen the couplings from the
whirlpool piping (photo # 2).
4. Remove the spacer pipe leaving the gaskets on
the whirlpool pipe connections (photo #3).
NOTE-Gaskets must be in place to ensure a
watertight seal.