Instruction Manual

17
Power : 3V CR123A Lithium Battery (replaceable)
Test/Silence Button: Test horn & silences Detector for 10 min.
Operating Temperature : 4.4°C to 37.8°C (40°F to 100°F)
Humidity Range : 15% to 95% R.H. (non-condensing)
Audible Sounder: >85dB(A) at 3m (10ft) minimum
RF Frequency: 900MHz Two-way
Current Drain : Typical 9µA Standby
Heat Sensor Fixed Rating : 57ºC +/- 2ºC (135°F +/- 5°F)
Heat Sensor Rate of Rise : >40ºC (104ºF) 8.3ºC (15ºF) / min
Panel Compatibility: ELK-M1 Control with ELK-M1XRFTWM
Two-Way Wireless Receiver for Interconnection.
Dimensions: 120mm (4.7”) x 46mm (1.8”)
Weight (grams): 210g (0.46 lbs)
FCC AND IC COMPLIANCE STATEMENT:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
NOTE: ELK PRODUCTS IS NOT RESPONSIBLE FOR
ANY CHANGES OR MODIFICATION NOT EXPRESSLY
APPROVED BY THE PARTY RESPONSIBLE FOR
COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE
USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment
o󰀨 and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit di󰀨erent
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes : (1) l’appareil ne
doit pas produire de brouillage, et (2) l’utilisateur de l’appareil
doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
FCC ID: TMAELK-6052 IC: 4353A-6052
10. Technical Specification