Installation Manual

ELK-M1XRF319 Installation Manual Page 15
Once the rst Wireless Receiver has been installed and operational additional receivers can be installed for redundancy or im-
proved coverage and range. Each addtional Wireless Receiver must be assigned its own data bus address and must be enrolled
into the control. The data bus address setting of any additional Wireless Receivers can be any unused data bus address from 2 to
10. ADDRESS 11, 12, 13, 14, 15, or 16 CANNOT BE USED.
NOTE: Wireless Receiver expanders MUST NEVER be assigned to addresses currently occupied by Hardwired Expand-
ers, and vice versa. In the example below the rst Wireless Receiver (in center) is assigned as Address 2. The additional
Receivers are Addresses 3 and 4. In theory it is possible to install up to 9 total Wireless Receivers on a single M1 Control
provided none of those addresses are being used by a Hardwired Expander.
*ForlargeinstallationsoraddedcoverageinareasexperiencingpoorwirelessconditionsadditionalWirelessReceiverscanbeconnectedtothedatabus.EachReceiver
mustbeassigneditsownBusAddressandbeenrolledforpropersupervision.LossofanyenrolledbusdevicecausesaMissingBusDeviceTrouble.
Offices
Shipping
FirstWireless
Receiver
BusAddress2
Warehouse
Production Sales
ExampleoflargerCommercialBuildingwith3WirelessReceivers
AdditionalWireless
Receiver
BusAddress3
AdditionalWireless
Receiver
BusAddress4
Appendix C - Installing Multiple Redundant Receivers