Installation

Page 7 1000005818 (Rev. A - 06/20)
1000005817
FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.834.4816
REPAIR SERVICE INFORMATION TOLL FREE NUMBER 1.800.260.6640
PRINTED IN U.S.A.
ELKAY MANUFACTURING COMPANY • 1333 BUTTERFIELD ROAD SUITE 200 DOWNERS GROVE, IL 60515 • 630.574.8484 • www.elkay.com
● Push the water line down so it can be connected to the evaporator. Push the water line into the tting on the evaporator until it is up to the line that
was drawn on the water line earlier.
● Spin the fan blade to ensure it spins freely and there are not any wires or that the water line is not in it.
● Place the (4) screws back in to hold the basin/shroud assembly to the frame.
● Reconnect the P-trap.
● Remove the plastic covering the sensor bar.
● Turn on the water and plug the cooler back in. Place a cup over the bubbler and activate the sensor. Run water until all air is removed from the
system and there is a steady stream of water coming from the bubbler.
● Check for any water leaks and x as needed.
● Place the lower wrapper on the cooler and tighten the (4) screws.