Full Product Manual

INSTALLATION INSTRUCTIO NS
The filter must be installed in compliance with all state and
local laws and regulations governing the installation and use of
this product.
Disconnect electrical power and close water supply valve
before proceeding.
The filter must be installed in the cold water line.
Flow indicator (arrow) on filter should point in the same direc-
tion as the water flow.
After installing new filter, open water supply valve and check for
leaks. Reconnect elect
rical power supply. Flush system suffi-
ciently (approximately 3 minutes) to effectively remove small
residue of carbon fines.
NOTE: A water shutoff valve should be installed o n the incom-
ing water line to aid in future servicing of filter.
CAUTION
• Filter is designed to reduce lead from incoming water to
levels below EPA requirements. Do not use with water that is
microbiolo gically unsafe or with water of unknown quality
without adequate disinfection before or after th
e system.
• Use on cold water line only. Do not allow installed filter to
freeze. Do not attach hot water line to filter.
•
Filt er sho uld b e rep lac ed every 3000 g allo ns (11,356 lit ers), o r
approximately 1 year after installation.
12-1/2"
(318mm)
1/2"
(31mm)
3-1/4"
(83mm)
Elkay
2222 Camden Court
Oak Brook, IL 60523
elkayusa.com
Printed in U.S.A.
© 2010 Elk ay
16- 37 (Rev. 2/10)
Wat er Sent ry
®
VII
L e a d R e d u c t i o n a n d
Sedim ent -Tast e-Odor Filt er K it
M o d e l E W F 3000 and 51300C
®
SP E C I FI C ATI O N S
Model EWF3000 shown which includes the complete
filter and bracket assembly for initial mounting.
Replacement model 51300C includes the filter
assembly only. Also available in a three-pack as
model 51300C_3PK.