Installation

ManualsBrandsElkay ManualsPlumbingEndura II Collection Floor Mounted or Freestanding Outdoor Pedestal Tubular Fountain with Non-Filtered, Non-Refrigerated and Freeze Resistant in Beige

PAGE 1 1000004236 (Rev. A - 08/17)

4410FR_FTN_A LK4410FR_FTN_A

Owners Manual

Model 4410FR Tubular Fountain

with Sanitary Freeze Resistant Single Valve Control Assembly

4410FR Fountains are among the easiest to install Fountains on the market today. To assure

you install these models easily and correctly, PLEASE READ THESE SIMPLE INSTRUCTIONS

BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE

WITH PLUMBING, ELECTRICAL, AND OTHER APPLICABLE CODES. After installation, leave

these instructions with the Fountain for future reference.

INSTALLER

Summary of content (9 pages)

PAGE 1
4410FR_FTN_A LK4410FR_FTN_A Owners Manual Model 4410FR Tubular Fountain with Sanitary Freeze Resistant Single Valve Control Assembly INSTALLER 4410FR Fountains are among the easiest to install Fountains on the market today. To assure you install these models easily and correctly, PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE WITH PLUMBING, ELECTRICAL, AND OTHER APPLICABLE CODES.
PAGE 2
4410FR_FTN_A LK4410FR_FTN_A INSTALLATION INSTRUCTIONS IMPORTANT ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON IMPORTANT! INSTALLER PLEASE NOTE. THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE BUILDING.
PAGE 3
4410FR_FTN_A LK4410FR_FTN_A SUGGESTED SITE PREPARATION DETAIL FOR THE 4410FR FTN. WHEN USING THE SANITARYFR1 VALVE 1-1/2" DRAIN TUBE (SUPPLIED BY INSTALLER) 4" PVC 1/4 BEND (SUPPLIED BY INSTALLER) 4" PVC PIPE (SUPPLIED BY INSTALLER) CONCRETE SLAB CLEANOUT PLUG FOR ACCESS (SUPPLIED BY INSTALLER) 4" 102mm MIN. 8 INCH INSIDE DIA. PVC PIPE, TRIM TO DESIRED LENGTH (SUPPLIED BY INSTALLER) 36" MIN. (914mm) 60"MAX. (1524mm) FROST LINE PVC 8" x 8" x 4" COMBINATION "Y" & 1/8 BEND REDUCING ASSY.
PAGE 4
410FR_FTN_A LK4410FR_FTN_A SUGGESTED SITE PREPARATION DETAIL FOR THE 4410FR FTN. WHEN USING THE SANITARYFR1 VALVE O 14" 356mm (6) 1/2" (13mm) DIA. HOLES EQUALLY SPACED ON A 12" ( 305mm ) BOLT CENTER 1-1/4 DRAIN TUBE SUPPLIED WITH FTN. AIR GAP ASSY. SUPPLIED WITH VALVE 29" 737mm 2 11/16" 68mm A SEE DETAIL A 27" 686mm A B 19" 483mm 27 1/8" 689mm 34 9/16" 878mm ORIFICE HEIGHT 33 7/16" 850mm 1-1/2 DRAIN TUBE SUPPLIED BY INSTALLER 7 11/16" 195mm 4" 102mm CONCRETE SLAB 36" MIN. (914mm) 60" MAX.
PAGE 5
4410FR_FTN_A LK4410FR_FTN_A E G C H A FOUNTAIN CONNECTIONS PLUMBING CONDUIT (BY INSTALLER) TO VALVE FIG. 3 INSTRUCTIONS FOR CONNECTING TUBES FROM VALVE TO FOUNTAIN Step 1 - Insert the 1/8” O.D. tube (Label A) into the connector (provided with fountain). Insert the 1/8” O.D. tube coming from the fountain push button actuator into the connector. Trim any excess length. Step 2 - Secure the 1/8” O.D. tube (Label C) to the waste line assembly. This line is a vent line and should be open to the air.
PAGE 6
4410FR_FTN_A LK4410FR_FTN_A 5 6 5 4 3, 11 Stream Height Adjustment 6 12 13 14 14 2 10 FIG. 4 1000004236 (Rev. A - 08/17) FIG.
PAGE 7
4410FR_FTN_A LK4410FR_FTN_A The Following Items are included with the SanitaryFR1 Valve PARTS LIST ITEM NO. PART NO. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 NS 110175443890 45806C 50986C 56082C 56092C 56123C 56185C 75653C 1000003970 56218C 98678C 70817C 70828C 75639C 75652C 70683C DESCRIPTION Hex Nut - 3/8-16 Single Valve Regulator Holder Regulator Nut Poly Tubing - 1/4” (Cut To Length) - To Bubbler Poly Tubing - 1/8” (Cut To Length) - To Actuator Canister Nylon Strap - 6 ft. Air Gap Assy.
PAGE 8
4410FR_FTN_A LK4410FR_FTN_A TROUBLESHOOTING AND MAINTENANCE Insufficient Bubbler Flow: Check that the shut-off valve is wide open. Verify minimum 20 PSI supply pressure. Clean inlet strainer screen located in the valve body. Clean rubber orifice in flow control located below frost line in bushing between barb fitting and valve. No Flow: Check for leaks in the air tubing going from the push button to the valve. Make sure the air tubing compression nut is hand tight. Disconnect air tube from push button.
PAGE 9
4410FR_FTN_A LK4410FR_FTN_A The Following Items are included with the 4410FR Fountain PARTS LIST ITEM NO. 16 17 18 19 20 21 22 23 24 25 25a 25b NS NS NS PART NO.