1000005236

• Elkay recommends that drop-in sinks be installed by a professional, experienced installer.
• Elkay is not responsible for the sink or countertop if damaged during installation.
• Metal edges may be sharp. Use caution when handling.
• Follow all local plumbing and building codes.
• Inspect sink for damage prior to beginning installation.
Required Tools (not included)
Installation
Attention Installer:
Position the sink upside down on
the countertop.
Trace a line around the edge of the sink.
Draw a line 5/16" inside of the outline of
the sink.
Cut Resistant
Drill a pilot hole in all four corners of the
inside line.
Use a saber or jig saw to cut on the
inside line.
Place a support underneath the cutout
portion of the countertop to prevent it from
falling during cutting.
Apply silicone caulk (not included)
around the cutout in the
countertop surface.
Carefully lower the sink into the cutout.
Assemble the clips and screws.
From the underside, place a clip in the
center along each side and hand tighten to
hold sink in place. Fasten the remaining
clips along the edges and space them
approximately 3" from each end, and
equally along the font, back, and sides.
For countertops thicker than 3/4", clips can
be spaced as close as 1-1/2".
From the top, check the seal between the
sink edge and countertop. Lightly tighten
clips evenly with a screwdriver until the
sink is tight to the countertop. Do not
over tighten.
Wipe away any excess caulk with a rag.
Installation Instructions:
Drop-in Sinks
WARNING: Always wear safety goggles and gloves when using
power tools or handling the sink to prevent personal injury.
Installation Profile
Sink
Screw
Clip
Silicone caulk
(Not furnished)
Countertop
Silicone caulk
(Not furnished)
1333 Butterfield Road, Suite 200 | Downers Grove, IL 60515 | elkay.com ©2019 Elkay Manufacturing Company (8/19) 1000005236.pdf
3
2
1