Installation Sheet

STEPS:

Screw quick connect assembly to the free end of hose.

Align male fitting (1) and tabs (2) on quick connector.

Push quick connector housing firmly upward and snap

onto receiving male fitting. Pull down moderately to

ensure connection has been made.

Important: after installation is completed, turn on hot

and cold water supplies. Check for leaks. Remove

the spray head by unscrewing it from the hose

counterclockwise. Turn the faucet on to the warm

position where it mixes hot and cold water. Flush

water lines for one minute. Check for leaks.

Re-tighten any connections if necessary, but do not

overtighten. Reinstall spray head by hand tightening

it back onto the hose.

WARNING: Please carefully read and properly follow the instructions for installation found in this manual.

Make connections to water lines.

Use 1/2" I.P.S. faucet connections (1) or use coupling

nuts (3) with 3/8" O.D.ball-nose riser (2). Use

wrenches to tighten connections. Do not overtighten.