Installation Instructions

ManualsBrandsElkay ManualsDrinking FountainsElkay 7.5 GPH Child ADA Wall Mount Single Level Slimline VR Cooler with VR Bubbler

FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620

97153C (Rev. F - 8/11)

37 3/4"

959mm

4 1/2

114mm

18 3/4"

476mm

5 1/8"

130mm

BACK OF WALL TO

BE 12" (305mm)

MIN DEPTH

203mm

TO FLOOR LINE

FLOOR LINE

WOOD OR STEEL FRAME SHOWN

(NOT PROVIDED)

ELECTRICAL INLET

LOCATION ON CHILLER

25mm

CHILLER SHELF

P/N 27638C

HOOK RODS (2)

P/N 101567443730

SCREWS OR BOLTS

(NOT PROVIDED)

5/16" SCREWS OR BOLTS

(10 REQ'D-NOT PROVIDED)

FRAME

INSTALL (2) SCREWS

(P/N 111008343890) IN FRAME

BEFORE INSTALLING IN OPENING

IMPORTANT:

DOUBLE STUD OR 3 INCHES (76mm)

BETWEEN MOUNTING FRAMES

IF PLACED NEXT TO A BOTTLE

FILLER UNIT

1. Cut a square rectangular wall opening 18 3/4" (476mm) W x 37 3/4" (959mm) H and 4 1/2" (114mm)

above the floor line. These dimensions are required to obtain proper rim and bubbler heights for

compliance with ANSI standard A117.1.

2. Reinforce the wall opening on all sides so that it will adequately support the water fountain. This

reinforcement must support up to 150 lbs static load and provide a means for securing the frame

assembly in place.

NOTE: Building construction must allow for adequate air flow on both sides and top of remote chiller

unit. Minimum of 4" (102mm) is required.

3. Install plumbing and electrical rough-ins. A junction box for a (3) wire, 10 amp branch circuit is

provided on the inside of the chiller. (Standard 120 Volts, 60 Hz and single phase)

4. Remove frame and related hardware from packaging. Release the two shelf rods by cutting cable ties.

Install the frame squarely in wall opening with frame upright edges flush with the finished wall face.

Place shelf inside frame and line up the (2) holes on each. Insert loose ends of rods into

holes on sides of shelf panel. Using appropriately sized screws or bolts (not provided), fasten the shelf

and frame to bottom of wall opening. Secure the frame sides and top to the wall using (10) 5/16" bolts

or screws (not provided).

NOTE: Be sure that frame is squared in location. Do not use less than the required screw quantity and

size.

SINGLE-STATION MOUNTING FRAME INSTRUCTIONS

ACTUAL FRAME MAY VARY

FROM THE ONE ILLUSTRATED.

REFER TO YOUR MODEL FOR

ADDITIONAL INFORMATION.