Installation Sheet

Page 2 of 4
Test fit sink to make sure sink fits into opening and
sink bowl flanges rest on countertop.
Remove sink. Create a rabbet cut 0.090" deep x
0.75" wide around the sink opening (Figure 3).
0.75"
0.090"
Figure 3
Figure 4
Figure 5
Test fit sink to make sure the glass rim is
sitting on the counter (Figure 4). If the sink
flange prevents the glass from sitting on the
counter, increase the depth of the rabbet
by 0.01" increments and test again.
With sink in place, check faucet hole cutout
location and adjust cutout locations as
necessary.
YES
NO
Remove sink.
Use a 1-1/2" hole saw to cut faucet holes
following the countertop manufacturer’s
recommended instructions.
(Figure 5).
+ +
GlassGlass
Gap
Counter
Counter