Installation Instructions

WIDTH
LENGTH
1/4" RADIUS ON
ALL4CORNERS
INSTALLATION
1. Position sink on countertop. Take into consideration
adequate clearance for the faucet, backsplash, and
any accessories such as a soap/lotion dispenser.
2. Cut countertop opening following the countertop
manufacturer’s recommended instructions.
3. Test cutout by placing the sink into the cutout.
4. Install faucet(s) (not included) and drain(s) (not
included) that will be connected to the sink following
the appropriate manufacturer’s recommended
instructions.
5. Clean underside of sink flange and sealing surface
of countertop opening thoroughly to remove dirt or
residue. Thoroughly dry and apply a continous
bead of a high quality silicone adhesive caulk (not
furnished) to the underside of the sink flange near
the edge. Position sink into countertop opening.
6. From the underside of the sink, place one clamp
near the center and tighten by hand enough to
hold the sink in place. This applies to all four
sides. Fasten remaining clamps in position and
hand tighten. (Usually 3 clamps on end, remaining
divided equally front and back). Space clamps as
equally as possible.
For countertops thicker than
3/4” up to 1-1/2”, Elkay recommends using LK364.
7. Remove any excess caulk and allow it to properly
cure following caulk manufacturer’s recommended
instructions.
8. Install supply lines, drain fittings, and other items.
Run water and check for leaks.
ECTSR UNIVERSAL MOUNT STAINLESS
STEEL SINK
II. TOP MOUNT INSTALLATION
Model
Length
Left-to-Right
Width
Front-to-back
ECTSR13169BG 12-3/8 15-3/8
14-3/8
21-3/8
21-3/8
ECTSR15159BG 14-3/8
24-3/8
24-3/8
ECTSRAD25226BG
ECTSR25229BG
21-3/8
32-3/8
ECTSRAD33226BG
21-3/8
32-3/8
ECTSR33229BG
21-3/8
32-3/8
ECTSRO33229RBG
21-3/8
32-3/8
ECTSRS33229BG
Cutout in Countertop (1/4" radius in corners)
COUNTERTOP
FASTENER
(OPTIONAL: LK364)
SINK
CHANNEL
MOUNTING
CLAMP
SILICONE CAULK
(NOT FURNISHED)