Installation Sheet

ManualsBrandsElkay ManualsPlumbingQuartz Classic Perfect Drain Undermount 25 in. Laundry Sink in Mocha

• Elkay recommends that drop-in sinks should be installed by a professional, experienced installer.

• Elkay is not responsible for the sink or countertop if damaged during installation.

• The clips provided are designed for a maximum countertop thickness of 1-3/4".

• The faucet deck must be supported on both sides while punching the faucet holes.

• Follow all local plumbing and building codes.

• Inspect sink for damage prior to beginning installation.

Required Tools (not included)

Installation

Attention Installer:

Position the sink upside down on the

countertop. Trace a line around the edge

of the sink.

Draw a line 5/16" inside of the outline of

the sink.

Drill a pilot hole in all four corners of the

inside line. Use a saber or jig saw to cut on

the inside line.

Place a support underneath the cutout

portion of the countertop to prevent it from

falling during cutting.

Identify the faucet holes by the emboss on

the underside of the faucet deck and the

corresponding circular labels located on the

top surface.

Before punching the holes please verify that

the circular labels are properly centered over

the faucet emboss. The faucet hole should be

carefully penetrated from above the sink using

chisel or screw driver and tapping lightly on the

circular labels.

If necessary the hole can been enlarged using

a metal hole saw, a jigsaw with a metal cutting

blade, or a metal ﬁle.

Determine if you sink was shipped with the

Orange Dowel Clip or the Black/Gray Slotted

Screw Clip.

Based on your clip type, align the clips with

the corresponding slots or holes. It may be

necessary to use a hammer and wood block

or screw driver to push clips into place.

Make sure metal portion of the clip is in the

open position.

Apply silicone caulk (not included) around

the cutout in the countertop surface.

Carefully lower the sink into the cutout.

Swing metal portion of clip (clamp) into the

clip base. Using a Phillips screw driver, turn

screw until clamp engages the countertop.

Use shims if necessary.

Wipe away any excess caulk with a rag.

Installation Instructions:

Quartz Drop-in Sinks

WARNING: Always wear safety goggles and gloves when using

power tools or handling the sink to prevent personal injury.

Silicone caulk

(Not furnished)

1333 Butterﬁeld Road, Suite 200 | Downers Grove, IL 60515 | elkay.com

SILICONE CAULK

(NOT INCLUDED)

CLOSED

CLAMP

Black/Gray Slotted Screw Clip

Orange Dowel Clip

CLIP

BASE

SINK

PLASTIC

PINS