Installation Instructions

;""
;0--08#---0%#-1-6.$+/)#/&$6+-&+/)%0&'4
;'(03'+/45#--#5+0/1-'#4'+/41'%55*'4+/,(03&#.#)'0/05+/45#--#&#.#)'&4+/,
;03&301+/4+/,4130%''&504'%5+0/I036/&'3.06/54+/,4130%''&504'%5+0/II
I
Note: The clips provided are designed for a maximum counter-
top thickness of 1-3/4".
1. To determine the proper size opening for your sink place
the sink upside down on top of the countertop. Mark or
trace a line around the edge of the rim. Then cut a hole
5/16" inside this line. (See illustration A)
2. Set new sink in opening to see that it fits properly.
3. Faucet Holes: Faucet holes can be identified by the faucet
hole emboss on the underside of the faucet deck and the
corresponding circular labels located on the faucet deck
top surface. Before punching the holes please verify that
the circular labels are properly centered over the faucet
hole emboss. The faucet hole should be carefully pene-
trated from above the sink
using a chisel or screw driver
and tapping lightly on the circular labels. (See illustration B).
If necessary the hole can be enlarged using a metal hole
saw, a jigsaw with a metal cutting blade or a metal file.
Note: Support faucet deck while punching faucet holes.
I
4. Attach faucet, drain fittings and accessories according to
the manufacturer’s instructions.
5. As shown in illustration C and D, align clips with the corre-
sponding holes in the sinks and gently push into place.
Push plastic pins on the clips inward completely so that
the clip expands and engages the sink. Note that it may be
necessary to use a nail punch and hammer to push pin in
completely. Make sure metal portion of the clip (clamp) is
in the open position so that sink can be dropped into
cutout.
6. Apply a bead of a high quality silicone adhesive caulk to
the underside of the sink rim and position sink into coun-
tertop opening. CAUTION: Use only a high quality silicone
adhesive caulk.
7. Swing metal portion of clip (clamp) into the clip base, until
it clicks into place. Using a phillips screwdriver, turn screw
until clamp engages the countertop. Use shims if necessary.
8. Remove excess caulk and allow caulk to cure following the
caulk manufacturer’s instructions.
6#35'%*
<
+/,
Installation Instructions



CLAMP
CLIP BASE
SINK
PLASTIC
PINS

TRACE COMPLETELY
AROUND EDGE OF SINK
DRAW SECOND
LINE INSIDE SINK
OUTLINE (CUT LINE)
5/16"
TO BE REMOVED FOR USE BY THE OCCUPANT!
Note: Support the faucet deck when
punching out the faucet hole plug