Manualshelf

Installation Guide

ManualsBrandsElkay ManualsBathroom SinksAsana Lustertone Stainless Steel Undermount Oval Bathroom Sink with Overflow Drain
12
COUNTERTOP
MOUNTING
BRACKET
(OPTIONAL
ACCESSORY)
COUNTERTOP RECESSED
APPROX. 1/2"
SILICONE CAULK
(NOT FURNISHED)
SINK
1-1/8"
FASTENER
(NOT FURNISHED)
COUNTERTOP
COUNTERTOP
OVERHANG
APPROX. 1/8"
SINK
SILICONE CAULK
(NOT FURNISHED
)
FASTENER
(NOT FURNISHED)
MOUNTING
BRACKET
(OPTIONAL
ACCESSORY)
ATTENTION INSTALLER:
1) ELKAY RECOMMENDS THAT UNDERMOUNT SINKS SHOULD BE INSTALLED BY A PROFESSIONAL
EXPERIENCED INSTALLER.
2) ENCLOSED IN THE SINK CARTON IS A DUAL PURPOSE TEMPLATE THAT CAN BE USED TO MAKE
EITHER A 1/2” SINK RIM REVEAL OR A 1/8” NO REVEAL INSTALLATION (SEE PICTURES BELOW).
PLEASE USE CAUTION IN SELECTING THE CORRECT OUTLINE ON THE TEMPLATE FOR YOUR
DESIRED INSTALLATION TYPE. YOUR INSTALLER MAY ALSO RETRIEVE THE DESIRED DXF FILE
FROM OUR WEBSITE, WWW.ELKAY.COM.
3) ELKAY UNDERMOUNT SINKS SHOULD ONLY BE FASTENED TO A SOLID SURFACE COUNTERTOP
(I.E. GRANITE / CORIAN / SILESTONE ).
4) ELKAY IS NOT RESPONSIBLE FOR SINK OR COUNTERTOP IF DAMAGED DURING INSTALLATION.
5) METAL EDGES MAY BE SHARP – USE CAUTION WHEN HANDLING.
6) FOLLOW ALL LOCAL PLUMBING AND BUILDING CODES.
7) INSPECT SINK FOR DAMAGE PRIOR TO BEGINNING INSTALLATION.
INSTALLATION
1. Position template on countertop. Locate the
template front to rear, so that sink will not inter-
fere with the cabinet.
2.Trace a line around the template. Cut along the
inside of this line to provide opening.
3. Locate and drill the mounting holes (following
the countertop manufacturer’s instructions) as
s
hown below. Holes should allow even spacing
o
f mounting brackets a round the sink. Type of
fasteners to be as recommended by countertop
supplier.
4. Fasten mounting brackets (optional accessory -
LKUCLIP8) to countertop loosely.
5. Using a good quality silicone caulk, apply a bead
evenly all around the top of the sink flanges.
6. Position and align sink over the countertop
opening. Press silicone onto countertop.
7. Tighten fasteners until mounting brackets are
snug against sink.
8. Check alignment of si
nk to countertop opening.
9. Tighten down fasteners evenly. Be careful not to
overtighten. Remove excess silicone.
Installation Instructions
DUAL REVEAL
1/2" SINK RIM REVEAL 1/8" NO REVEAL INSTALLATION
®
®

Summary of content (2 pages)