Installation Guide

INSTALLATION
ATTENTION INSTALLER:
1. Position template on countertop. Locate the
template front to rear,so that sink will not inter-
fere with the cabinet.
2. Trace a line around the template. Cut along the
inside of this line to provide opening.
3. Locate and drill the mounting holes (following
the countertop manufacturer’s instructions) as
shown below.Holes should allow even spacing
of mounting brackets around the sink.Type of
fasteners to be as recommended by countertop
supplier.
4. Fasten mounting brackets (optional accessory-
LKUCLIP8) to countertop loosely.
5. Using a good quality silicone caulk, apply a bead
evenly all around the top of the sink flanges.
6. Position and align sink over the countertop
opening. Press silicone onto countertop.
7. Tighten fasteners until mounting brackets are
snug against sink.
8. Check alignment of sink to countertop opening.
9. Tighten down fasteners evenly. Be careful not to
overtighten. Remove excess silicone.
ELUH 1/2” REVEAL COUNTERTOP INSTALLATION
1/2” COUNTERTOP REVEAL
COUNTERTOP
MOUNTING
BRACKET
APPROX.1/2"
SILICONE CAULK
(NOT FURNISHED)
SINK
1-1/8"
(NOT FURNISHED)
1) ELKAY RECOMMENDS THAT UNDERMOUNT SINKS SHOULD BE INSTALLED BY A PROFESSIONAL
EXPERIENCED INSTALLER.
2) WARNING: THE ENCLOSED CUTOUT TEMPLATE WILL CREATE A COUNTERTOP OPENING THAT
WILL EXPOSE APPROXIMATELY 1/2” OF SINK RIM LEDGE. IT IS RECOMMENDED THAT YOU DIS-
CUSS THIS WITH YOUR CUSTOMER AND AGREE THAT THIS FINISHED APPEARANCE IS THE
DESIRED EFFECT. ELKAY IS NOT RESPONSIBLE FOR IMPROPER SINK OR COUNTERTOP INSTAL-
LATIONS. DUE TO THE AESTHETIC QUALITIES OF THE CONVERGING BOWL RADII, THE TEMPLATE
FURNISHED WITH EACH SINK PROVIDES THE ONLY OPENING RECOMMENDED FOR INSTALLATION
OF ELKAY UNDERMOUNT SINKS. SEE ILLUSTRATION BELOW.
3) ELKAY UNDERMOUNT SINKS SHOULD ONLY BE FASTENED TO A SOLID SURFACE COUNTERTOP
(I.E. GRANITE/CORIAN /SILESTONE ).
®
®
4) ELKAY IS NOT REPONSIBLE FOR SINK OR COUNDTERTOP IF DAMAGED DURING INSTALLATIONS.
5) METAL EDGES MAY BE SHARP - USE CAUTION WHEN HANDLING.
6) FOLLOW ALL LOCAL PLUMBING AND BUILDING CODES.
7) INSPECT SINK FOR DAMGAGE PRIOR TO BEGINING INSTALLATION.

Summary of content (2 pages)