Installation Guide

ATTENTION INSTALLER:
1) ELKAY RECOMMENDS THAT DROP-IN/SELF RIM SINKS SHOULD BE INSTALLED BY A PROFES-
SIONAL EXPERIENCED INSTALLER.
2) ELKAY IS NOT RESPONSIBLE FOR SINK OR COUNTERTOP IF DAMAGED DURING INSTALLATION.
3) METAL EDGES MAY BE SHARP – USE CAUTION WHEN HANDLING.
4) FOLLOW ALL LOCAL PLUMBING AND BUILDING CODES.
5) INSPECT SINK FOR DAMAGE PRIOR TO BEGINNING INSTALLATION.
INSTALLATION
1. Place sink upside down on countertop surface.
Place sink in exact position for installation and
pencil completely around sink to create a sink
outline.
2. Scribe actual opening 5/16" inside the sink out-
line, all the way around.
3. Cut out on inside of this line (following the man-
ufacturer’s instructions). If sink comes with a
faucet deck, install faucet to sink and tighten.
4. Apply a silicone sealer around entire perime
ter of
opening. Set bowl into opening.
INSTALLATION
5. Assemble screws into clamps. (Note: Screws are
designed to insert into clamps with backward
threading, so that in mounting, they will turn in
normal direction.) From underside of sink, place
one clamp near center of each channel, tighten
by hand enough to hold sink in place. This
applies to all sides. Space clamps as equally as
possible.
6. From the top si
de, check seal between rim
and countertop. Adjust clamps to high spot if
necessary.
7. Tighten clamp evenly with screwdriver in rotation
until sink is seated with countertop. Caution: Do
not overtighten clamps.
Installation Instructions
COUNTERTOP
SINK
SEALER
CLAMP
CHANNEL
SCREW
CLAMP DEVICE