Installation Sheet

ManualsBrandsElkay ManualsCommercial SinksElkay Stainless Steel 18" Wall Mount 18 Gauge Single Basin Bathroom Sink with 5-1/2" Backsplash and 2" Centers

PAGE 1

4420DBFR_FTN _A LK4420DBFR_FTN_A

1000003947 (Rev. A - 06/17)

INSTALLER

Owners Manual

Model 4420DBFR Bi-Level Tubular Fountain with Pet Fountain

and Sanitary Freeze Resistant Triple Valve Control Assembly

4420DBFR Fountains are among the easiest to install Fountains on the market today. To assure

you install these models easily and correctly, PLEASE READ THESE SIMPLE INSTRUCTIONS

BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE

WITH PLUMBING, ELECTRICAL, AND OTHER APPLICABLE CODES. After installation, save

these instructions for future reference.

Summary of content (9 pages)

PAGE 1
4420DBFR_FTN _A LK4420DBFR_FTN_A Owners Manual Model 4420DBFR Bi-Level Tubular Fountain with Pet Fountain and Sanitary Freeze Resistant Triple Valve Control Assembly INSTALLER 4420DBFR Fountains are among the easiest to install Fountains on the market today. To assure you install these models easily and correctly, PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE WITH PLUMBING, ELECTRICAL, AND OTHER APPLICABLE CODES.
PAGE 2
4420DBFR_FTN _A LK4420DBFR_FTN_A INSTALLATION INSTRUCTIONS IMPORTANT ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON IMPORTANT! INSTALLER PLEASE NOTE. THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE BUILDING.
PAGE 3
4420DBFR_FTN _A LK4420DBFR_FTN_A SUGGESTED SITE PREPARATION DETAIL FOR THE 4420FR FTN. WHEN USING THE SANITARYFR3 VALVE 1-1/2" DRAIN TUBE (SUPPLIED BY INSTALLER) 4" PVC 1/4 BEND (SUPPLIED BY INSTALLER) 4" PVC PIPE (SUPPLIED BY INSTALLER) CONCRETE SLAB CLEANOUT PLUG FOR ACCESS (SUPPLIED BY INSTALLER) 4" 102mm MIN. 8 INCH INSIDE DIA. PVC PIPE, TRIM TO DESIRED LENGTH (SUPPLIED BY INSTALLER) 36" MIN. (914mm) 60"MAX. (1524mm) FROST LINE PVC 8" x 8" x 4" COMBINATION "Y" & 1/8 BEND REDUCING ASSY.
PAGE 4
420DBFR_FTN _A LK4420DBFR_FTN_A SUGGESTED SITE PREPARATION DETAIL FOR THE 4420DBFR FTN. WHEN USING THE SANITARYFR3 VALVE 1-1/2 DRAIN TUBE SUPPLIED WITH FTN. AIR GAP ASSY. SUPPLIED WITH VALVE ( 4 ) 1/2" ( 13mm ) DIA. HOLES SPACED AS SHOWN ON A 12" ( 305mm ) BOLT CENTER (2 PL) 22" 559mm O 14" 356mm (2 PL) 29" 737mm O 10" 254mm SEE DETAIL A 34 9/16" 878mm 41 7/16" 1053mm A 8" 203mm B 19" 483mm 1-1/2 DRAIN TUBE SUPPLIED BY INSTALLER 27 1/8" 689mm Detail A 4" 102mm 36" MIN. 914mm 60" MAX.
PAGE 5
4420DBFR_FTN _A K J D F G H C B FOUNTAIN CONNECTIONS E LK4420DBFR_FTN_A L A PLUMBING CONDUIT (BY INSTALLER) TO VALVE FIG. 3 INSTRUCTIONS FOR CONNECTING TUBES FROM VALVE TO FOUNTAIN(S) Step 1 - Insert the 1/8” O.D. tube(s) (Labeled A, B & J) into the connector(s) (provided with fountain). Insert the 1/8” O.D. tube(s) coming from the fountain(s) push button actuator(s) into the connector(s). Trim any excess length. Step 2 - Secure the 1/8” O.D. tube(s) (Labeled C, D & K) to the waste line assembly.
PAGE 6
4420DBFR_FTN _A LK4420DBFR_FTN_A Stream Height Adjustment 6 3 14 2 5,13 7 8 8 8 SEE DETAIL B 8 16 8 8 8 8 7 4 15 12 DETAIL B FIG. 4 1000003947 (Rev.
PAGE 7
4420DBFR_FTN _A LK4420DBFR_FTN_A The Following Items are included with the SanitaryFR3 Valve PARTS LIST ITEM NO. PART NO.
PAGE 8
4420DBFR_FTN _A LK4420DBFR_FTN_A 22 18 27 22 31 22 33 18 Included with Sanitary Valve 27 23 22 18 25 29 30, 30a, 30b 26 34 32 24 28 19 32 21 20 29 1000003947 (Rev. A - 06/17) PAGE 8 FIG.
PAGE 9
4420DBFR_FTN _A LK4420DBFR_FTN_A TROUBLESHOOTING AND MAINTENANCE Troubleshooting Insufficient Bubbler Flow: Check that the shut-off valve is wide open. Verify minimum 20 PSI supply pressure. Clean inlet strainer screen located in the valve body. Clean rubber orifice in flow control located below frost line in bushing between barb fitting and valve. No Flow: Check for leaks in the air tubing going from the push button to the valve. Make sure the air tubing compression nut is hand tight.