Specification Sheet

ManualsBrandsElkay ManualsCommercial PlumbingSwirlFlo 38-1/2" Wall Mounted Bi-Level Drinking Station with Cooler

97924C (Rev. G - 2/12)

ERPB2-8C, ERPB2-8RAC, ERPBV2-8C, ERPBV2-8RAC, LRPB2-8C, LRPB2-8RAC, ERPB2-8C*2C, ERPB2-8C*3C

ERPB2-8GRNC*A, ERPB2-8GRNRAC*A, LRPB2-8GRNC*A, LRPB2-8GRNRAC*A

Page 1

Review these instructions before beginning installation. Be sure that installation

conforms to all plumbing, electrical and other applicable codes.

When installation is complete, ensure these instructions are left in the plastic bag

provided inside the installed unit for future reference.

Service to be performed by authorized service personnel only.

INSTALLER

NOTE: It is common practice to ground electrical hardware such as telephones, computers and other devices

to available water lines. This can, however, cause electrical feedback in the plumbing circuit, which

results in an “electrolysis” effect occurring in the fountain. This may result in water which has a metallic

taste to it or has a noticeable increase in the metallic content of the water.

When inspecting plumbing circuit, remember the line may be grounded some distance from the

installation, and may occur outside the building or area in which the unit is being installed.

This condition can be avoided (in most cases) by using recommended materials during installation. Any

drain fittings provided by the installer should be made of plastic which will electronically isolate the

fountain from the remainder of the building’s plumbing circuits.

ERPB2-8C ERPB2-8RAC

SWIRLFLO Refrigerated fountains with FLEXI-GUARD

INSTALLATION, CARE & USE MANUAL

Summary of content (8 pages)

PAGE 1
ERPB2-8C, ERPB2-8RAC, ERPBV2-8C, ERPBV2-8RAC, LRPB2-8C, LRPB2-8RAC, ERPB2-8C*2C, ERPB2-8C*3C ERPB2-8GRNC*A, ERPB2-8GRNRAC*A, LRPB2-8GRNC*A, LRPB2-8GRNRAC*A INSTALLATION, CARE & USE MANUAL TM TM SWIRLFLO Refrigerated fountains with FLEXI-GUARD ERPB2-8C ERPB2-8RAC INSTALLER Review these instructions before beginning installation. Be sure that installation conforms to all plumbing, electrical and other applicable codes.
PAGE 2
97924C (Rev. G - 2/12) LEGEND A = 1/4” O.D. Tube - Water Outlet Connection B = 3/8” O.D.
PAGE 3
ERPB2-8C, ERPB2-8RAC, ERPBV2-8C, ERPBV2-8RAC, LRPB2-8C, LRPB2-8RAC, ERPB2-8C*2C, ERPB2-8C*3C ERPB2-8GRNC*A, ERPB2-8GRNRAC*A, LRPB2-8GRNC*A, LRPB2-8GRNRAC*A REQUIRED TOOLS AND MATERIALS These tables show special tools and/or additional materials (not provided) which are necessary to complete installation of these units: Special Tools Item Description Quantity NONE Additional Materials Item Figure 2 - Chiller Installation Description 1 Unplated copper inlet pipe 2 Service Stop Quantity 1.
PAGE 4
ERPB2-8C, ERPB2-8RAC, ERPBV2-8C, ERPBV2-8RAC, LRPB2-8C, LRPB2-8RAC, ERPB2-8C*2C, ERPB2-8C*3C ERPB2-8GRNC*A, ERPB2-8GRNRAC*A, LRPB2-8GRNC*A, LRPB2-8GRNRAC*A 5. Hang the upper panel on the mounting frame hanger. Be sure that the panel is engaged with hanger at the top of frame before releasing it. Align holes in the panel with holes in the mounting frame. Install two (2) #10-24 x 5/8” (16mm) screws (Item 29 - Figure 5) in holes and tighten securely. 29, 30, 31, 32 6. Install the fountain.
PAGE 5
ERPB2-8C, ERPB2-8RAC, ERPBV2-8C, ERPBV2-8RAC, LRPB2-8C, LRPB2-8RAC, ERPB2-8C*2C, ERPB2-8C*3C ERPB2-8GRNC*A, ERPB2-8GRNRAC*A, LRPB2-8GRNC*A, LRPB2-8GRNRAC*A 7 7 1 2 8 8 4, 5, 6 3, 5, 6 Basin Basin 9 9 FLEXI-GUARD® STREAMSAVER™ BUBBLER DETAIL FLEXI-GUARD® BUBBLER DETAIL NOTE: When installing replacement bubbler and pedestal, tighten nut (Item 7) only to hold parts snug in position. Do Not Overtighten.
PAGE 6
ERPB2-8C, ERPB2-8RAC, ERPBV2-8C, ERPBV2-8RAC, LRPB2-8C, LRPB2-8RAC, ERPB2-8C*2C, ERPB2-8C*3C ERPB2-8GRNC*A, ERPB2-8GRNRAC*A, LRPB2-8GRNC*A, LRPB2-8GRNRAC*A 7 When provided 2 1 6 4 3 5 Figure 9 - Filter Assembly WaterSentry Filter Detail ® WATERSENTRY FILTER PARTS LIST (See Fig. 9) ITEM NO. PART NO. 1 2 3 4 5 6 7 97924C (Rev. G - 2/12) 51294C 70792C 70823C 70822C 51299C 70818C 22490C DESCRIPTION Filter Head Assy. Screw #8-18 x .
PAGE 7
ERPB2-8C, ERPB2-8RAC, ERPBV2-8C, ERPBV2-8RAC, LRPB2-8C, LRPB2-8RAC, ERPB2-8C*2C, ERPB2-8C*3C ERPB2-8GRNC*A, ERPB2-8GRNRAC*A, LRPB2-8GRNC*A, LRPB2-8GRNRAC*A 25 See Fig. 8 13 23 See Fig. 8 24 14 36 16 26 39 34 15 Figure 10 - Fountain Body Assembly 39 17 18 43 19 20 21 22 38 Figure 11 - Push Button Assembly Page 7 97924C (Rev.
PAGE 8
ERPB2-8C, ERPB2-8RAC, ERPBV2-8C, ERPBV2-8RAC, LRPB2-8C, LRPB2-8RAC, ERPB2-8C*2C, ERPB2-8C*3C ERPB2-8GRNC*A, ERPB2-8GRNRAC*A, LRPB2-8GRNC*A, LRPB2-8GRNRAC*A Installation Package 1/4" O.D. TUBE WATER INLET TO COOLER 3/8" O.D. UNPLATED COPPER TUBE CONNECT COLD WATER SUPPLY BUILDING WATER INLET The components for installation are packed in three separate boxes, regardless of the type of unit being installed. The boxes contain the following: Box No. 1: Wall Frame(s) Box No. 2: Remote Chiller, ECH8 Box No.