Instructions / Assembly

ManualsBrandsElkay ManualsKitchenSwirlFlo ADA Bi-Level Refrigerated Drinking Fountain

97153C (Rev. G - 8/16)

For Technical Service, please contact us at 1.800.476.4106

Elkay - www.elkay.com

Halsey Taylor - www.halseytaylor.com

37 3/4"

(959mm)

4 1/2"

(114mm)

18 3/4"

(476mm)

5 1/8"

130mm

BACK OF WALL TO

BE 12" (305mm)

MIN DEPTH

(203mm)

TO FLOOR LINE

FLOOR LINE

WOOD OR STEEL FRAME SHOWN

(NOT PROVIDED)

ELECTRICAL INLET

LOCATION ON CHILLER

1 1/8"

(29mm)

(P/N 27638C

- PROVIDED)

(P/N 101567443730

- PROVIDED)

SCREWS OR BOLTS

(NOT PROVIDED)

5/16" SCREWS OR BOLTS

(10 REQ'D-NOT PROVIDED)

FRAME

IMPORTANT:

DOUBLE STUD OR 3 INCHES (76mm)

BETWEEN MOUNTING FRAMES

IF PLACED NEXT TO A BOTTLE

FILLER UNIT

(P/N 111008343890

- PROVIDED)

1. Cut a square rectangular wall opening 18 3/4” (476mm) W x 37 3/4” (959mm) H and 4 1/2” (114mm)

above the oor line. These dimensions are required to obtain proper rim and bubbler heights for

compliance with ANSI standard A117.1.

2. Reinforce the wall opening on all sides so that it will adequately support the water fountain. This

reinforcement must support up to 150 lbs static load and provide a means for securing the frame

assembly in place.

NOTE: Building construction must allow for adequate air ow on both sides and top of remote chiller

unit. Minimum of 4” (102mm) is required.

3. Install plumbing and electrical rough-ins. A junction box for a (3) wire, 10 amp branch circuit is

provided on the inside of the chiller. (Standard 120 Volts, 60 Hz and single phase)

4. Remove frame and related hardware from packaging. Release the two shelf rods by cutting cable ties.

Install the frame squarely in wall opening with frame upright edges ush with the nished wall face.

Place shelf inside frame and line up the (2) holes on each. Insert loose ends of rods into holes on sides of

shelf panel. Using appropriately sized screws or bolts (not provided), fasten the shelf and frame to bottom

of wall opening. Secure the frame sides and top to the wall using (10) 5/16” bolts or screws (not provided).

NOTE: Be sure that frame is squared in location. Do not use less than the required screw quantity and

size.

SINGLE-STATION MOUNTING FRAME INSTRUCTIONS

ACTUAL FRAME MAY VARY

FROM THE ONE ILLUSTRATED.

PLEASE REFER TO THE

INSTALLATION/OWNERS MANUAL

OF THE SPECIFIC UNIT FOR

ADDITIONAL INFORMATION.

MF100