Installation Sheet

1. Uncrate the sink.

Remove the lid to the crate. Remove the front panel of the sink by releasing the latches. Remove all components and set

aside. 2 people recommended for this step: Carefully lift the sink out of the crate and sit upright. Discard packaging.

2. Install spout to deck.

Install the spout(s) in the upper deck whole aligned to the drain per the instructions enclosed in the

LK349A.

3. Install thermostatic mixing valve to deck.

Attach mixing valve to sink

deck using LK723L2 Install instructions and included hardware (cold input facing right and hot

input facing left as seen from front of sink). Adjust the Escutcheon Nut until just under the alignment splines. Black alignment

marks should line up with each other. The handle should point forward/center.

Knee Operated Surgical Scrub Sinks

Installation Instructions

PAGE 1
Installation Instructions Knee Operated Surgical Scrub Sinks 1. Uncrate the sink. Remove the lid to the crate. Remove the front panel of the sink by releasing the latches. Remove all components and set aside. 2 people recommended for this step: Carefully lift the sink out of the crate and sit upright. Discard packaging. 2. Install spout to deck. Install the spout(s) in the upper deck whole aligned to the drain per the instructions enclosed in the LK349A. 3. Install thermostatic mixing valve to deck.
PAGE 2
4. Install soap spout to sink wall. (Optional – only if soap dispensing option ordered). Remove the nut from the spout. Feed the spout through the 3/8” hole from the back side. Reinstall the nut and tighten appropriately. Push one end of the included tube over the back spout opening. Use pliers to slide a clamp over the end of the tube. Allow the tube to dangle until subsequent steps. 5. Attach water lines.
PAGE 3
8. Attach the soap pump. Loosen front/nut of soap pump and slide it into the bracket. Carefully wrench tighten. Pull the soap tube from earlier step forward to the rear outlet of the soap pump and cut. Slide a tube clamp onto the tube and push the tube coming from the soap spout on to the rear output of the soap pump. Use pliers to slide a clamp onto the end of the tube. Connect the remaining hose to the side inlet and clamp. The inlet tube can be trimmed and placed in the soap bottle.