EZF(S)4*1E EZF(S)8*1E,2D,3D EZF(S)D*1E LZF(S)8*1E,2D,3D LZF(S)D*1E INSTALLATION, CARE & USE MANUAL Manual de Instalación, Cuidado y Utilizaci Manuel d’installation/entretien/utilisation EZ™ & LZ™ Series Barrier-Free Water Coolers EZ™ & LZ™ La Barrera de la serie Liberta Agua Coolers EZ™ & LZ™ Coolers d’Eau de Barrière-Libère de feuilleton Page 1 98918C (Rev.
EZF(S)4*1E EZF(S)8*1E,2D,3D EZF(S)D*1E LZF(S)8*1E,2D,3D LZF(S)D*1E Note: Danger! Electrical shock hazard. Disconnect power before servicing unit. Nota: peligro! Peligro de descarga eléctrica. Desconecte antes de reparar la unidad Remarque : Danger ! Risque de choc électrique. Débrancher avant de réparer l’appareil. Uses HFC-134A refrigerant Usa refrigerante HFC-134A Utilise du fluide frigorigéne HFC-134A 23 21 1 5 18 11 8 14 4 12 13 See Fig. 4 or 5 See Fig.
F Page 3 7" 178mm 7" 178mm 2" 51mm 3 7/8" 98mm 28 13/16" 732mm 13 15/16" 354mm A E 2" 51mm C 8 1/16" 205mm FINISHED FLOOR ADA REQUIREMENT 27" 686mm RIM HEIGHT 31 11/32" 796mm ORIFICE HEIGHT 32 7/8" 835mm 12 1/2" 318mm 5 7/8" 150mm HANGER BRACKET REDUCE HEIGHT BY 3” FOR INSTALLATION OF CHILDREN’S ADA COOLER 5 3/4" 146mm CL 6 3/8" 162mm 19 1/32" 483mm 3" 77mm 2" 51mm LEGEND/LEYENDA/LÉGENDE A = RECOMMENDED WATER SUPPLY LOCATION 3/8” O.D.
EZF(S)4*1E EZF(S)8*1E,2D,3D EZF(S)D*1E LZF(S)8*1E,2D,3D LZF(S)D*1E HANGER BRACKETS & TRAP INSTALLATION 1) Remove hanger bracket fastened to back of cooler by removing one (1) screw. 2) Mount the hanger bracket as shown in Figure 2. NOTE: Hanger Bracket MUST be supported securely. Add fixture support carrier if wall will not provide adequate support. Anchor hanger securely to wall using all six (6) 1/4 in. dia. mounting holes. IMPORTANT: 5-7/8 in.
EZF(S)4*1E EZF(S)8*1E,2D,3D EZF(S)D*1E LZF(S)8*1E,2D,3D LZF(S)D*1E Service Instructions Lower and Upper Shroud To access the refrigeration system and plumbing connections, remove four screws from bottom of cooler to remove the lower shroud. To remove the upper shroud for access to the pushbars, regulator, solenoid valve or other components located in the top of the unit, remove lower shroud, disconnect drain, remove four screws from tabs along lower edge of upper shroud, unplug two wires and water tube.
EZF(S)4*1E EZF(S)8*1E,2D,3D EZF(S)D*1E LZF(S)8*1E,2D,3D LZF(S)D*1E NOTE: When installing replacement bubbler and pedestal, tighten locknut only to hold parts snug in position. Do Not Overtighten. NOTA: Al instalar el grifo y pedestal de reemplazo, apriete la tuerca unicamente para mantener las piezas en una posicion adjustada. No dede apretarse demasiado.
EZF(S)4*1E EZF(S)8*1E,2D,3D EZF(S)D*1E LZF(S)8*1E,2D,3D LZF(S)D*1E OVERLOAD Fig.8 Wiring Diagram Esquema eléctrico Diagramme de câblage 5B BLK 3 1 2 COLD CONTROL FAN 5 3 2 1 WHT 5A RELAY GREEN - GRND. 6 SOLENOID VALVE SMOOTH M S RIBBED C GND 230V PARTS LIST/ 230V LISTA DE PIEZAS/ 230V LISTE DES PIÈCES ITEM NO. 11 15 18 *16 17 NS NS NS NS PART NO.
EZF(S)4*1E EZF(S)8*1E,2D,3D EZF(S)D*1E LZF(S)8*1E,2D,3D LZF(S)D*1E 115V PARTS LIST/ 115V LISTA DE PIEZAS/ 115V LISTE DES PIÈCES DESCRIPTION ITEM NO. PART NO.
