EZF(S)TL8*1E, 2D, 3D EZF(S)TLR8*1E, 2D, 3D EZF(S)DTL*1E, 2D EZF(S)DTLR*1E LZF(S)DTL*1E LZF(S)DTLR*1E LZF(S)TL8*1E LZF(S)TLR8*1E INSTALLATION, CARE & USE MANUAL Manual de Instalación, Cuidado y Utilización Manuel d’installation/entretien/utilisation EZTL™ & LZTL™ Series Barrier-Free Water Coolers EZTL™ & LZTL™ La Barrera de la serie Liberta Agua Coolers EZTL™ & LZTL™ Coolers d’Eau de Barrière-Libère de feuilleton 43 14 5 33 14 43 38 34 17, 18 12 52 46 8 47 3 9 55 3 4 See Figure 6 or 7 54 54 5
98919C (Rev. B - 11/12) * * PAGE 2 * 19" 483mm 17 7/16" 443mm * F 7/8" 22mm 2" 51mm 6 3/8" 162mm D (ALT. LOCATION) D (PREFERRED LOCATION) 6 3/8" 162mm F * 7" 178mm 2" 51mm 6 3/8" 162mm E * 13 15/16" 354mm * 28 13/16" 732mm A (PREFERRED LOCATION) B 2" 51mm * * FIG. 2 * * C 12 1/2" 318mm *ADA REQUIREMENT *REQUISITO DE A.D.A.
B 2" 51mm PAGE 3 7" 178mm 2" 51mm 7/8" 22mm 6 3/8" 162mm DUMMY UNIT 3 7/8" 98mm 7" 178mm 6 3/8" 162mm REFRIGERATED UNIT D (PREFERRED LOCATION) A (ALT. LOCATION) 2" 51mm 6 3/8" 162mm 7/16" * 19494mm F E * 34 5/16" 872mm 2" 51mm * FIG.
EZF(S)TL8*1E, 2D, 3D EZF(S)TLR8*1E, 2D, 3D EZF(S)DTL*1E, 2D EZF(S)DTLR*1E LZF(S)DTL*1E LZF(S)DTLR*1E LZF(S)TL8*1E LZF(S)TLR8*1E HANGER BRACKETS & TRAP INSTALLATION 1) Remove hanger brackets (Item 43) fastened to back of cooler by removing one (1) screw. 2 ) Mount the hanger bracket as shown in Figure 2 or 3. NOTE: Hanger Brackets MUST be supported securely. Add fixture support carrier if wall will not provide adequate support. Anchor hangers securely to wall using all six (6) 1/ 4 in. dia. mounting holes.
EZF(S)TL8*1E, 2D, 3D EZF(S)TLR8*1E, 2D, 3D EZF(S)DTL*1E, 2D EZF(S)DTLR*1E LZF(S)DTL*1E LZF(S)DTLR*1E LZF(S)TL8*1E LZF(S)TLR8*1E Service Instructions 22 Lower and Upper Shroud 24 To access the refrigeration system and plumbing connections, remove four screws from bottom of cooler to remove the lower shroud.
EZF(S)TL8*1E, 2D, 3D EZF(S)TLR8*1E, 2D, 3D EZF(S)DTL*1E, 2D EZF(S)DTLR*1E LZF(S)DTL*1E LZF(S)DTLR*1E LZF(S)TL8*1E LZF(S)TLR8*1E 40 56 45 41 22, 23 & 24 49 48 Basin Estanque Bassin 48 10 50 BUBBLER DETAIL DETALLE DEL GRIFO DETAIL DU BARBOTEUR VANDAL RESISTANT BUBBLER DETAIL DETALLE DEL GRIFO RESISTENTE AL VANDALISMO DESCRIPTION DU BARBOTEUR RESISTANT AU VANDALISME FIG. 5 FIG. 6 NOTE: When installing replacement bubbler and pedestal, tighten nut (Item 10) only to hold parts snug in position.
EZF(S)TL8*1E, 2D, 3D EZF(S)TLR8*1E, 2D, 3D EZF(S)DTL*1E, 2D EZF(S)DTLR*1E LZF(S)DTL*1E LZF(S)DTLR*1E LZF(S)TL8*1E LZF(S)TLR8*1E 7 2 When provided Cuando provisto Si Fourni 1 6 4 3 5 FIG. 8 ® WATERSENTRY Filter Detail ® Detalle WATERSENTRY Filtro ® Description WATERSENTRY Filtrage ® WATERSENTRY FILTER PARTS LIST (See Fig. 8) ITEM NO. PART NO. 1 2 3 4 5 51294C 70792C 70823C 70822C 51299C 51300C 70818C 22490C 6 7 DESCRIPTION Filter Head Assy. Screw #8-18 x .
EZF(S)TL8*1E, 2D, 3D EZF(S)TLR8*1E, 2D, 3D EZF(S)DTL*1E, 2D EZF(S)DTLR*1E LZF(S)DTL*1E LZF(S)DTLR*1E LZF(S)TL8*1E LZF(S)TLR8*1E Switch Activation Note: Only side push activation is shown. Front push works the same. Detalle de la activación del interruptor Nota: Lateral presion activación que se muestran. Frontal presion es la similar. Description de l’activation de l’interrupteur Remarque: Laterel puossoir activación que des indique. Face puossoir des semblable.
EZF(S)TL8*1E, 2D, 3D EZF(S)TLR8*1E, 2D, 3D EZF(S)DTL*1E, 2D EZF(S)DTLR*1E LZF(S)DTL*1E LZF(S)DTLR*1E LZF(S)TL8*1E LZF(S)TLR8*1E COLOR TABLE / TABLA DE LOS COLORES / TABLE DE COULEURS ITEM NO. PART NO.
EZF(S)TL8*1E, 2D, 3D EZF(S)TLR8*1E, 2D, 3D EZF(S)DTL*1E, 2D EZF(S)DTLR*1E LZF(S)DTL*1E LZF(S)DTLR*1E LZF(S)TL8*1E LZF(S)TLR8*1E 115V PARTS LIST/ 115V LISTA DE PIEZAS/ 115V LISTE DES PIÈCES ITEM PART NO. NO.
