Installation Guide

ManualsBrandsElkay ManualsWater CoolersEZ Model Stainless Steel Fountain Cold Water Cooler

PAGE 1 1000003116 (Rev. B - 08/18)

EZFSTL8*1H, 2H LZFSTL8*1H, 2H EZFSDTL*1H LZFSDTL*1H

Versatile Cooler Models EZSTL8L and

LZSTL8L conguration as shipped

Versatile Cooler Models EZSTL8L and

LZSTL8L alternate installation

EZTL

™

& LZTL

™

Série versatile refroidisseurs d’eau à deux niveaux

EZTL

™

& LZTL

™

Serie versátil bi-nivel enfriadores de agua

EZTL

™

& LZTL

™

Series Versatile Bi-Level Water Coolers

INSTALLATION AND USE MANUAL

Manual de instalación y uso

Manuel d’installation et utilisation

Summary of content (9 pages)

PAGE 1
EZFSTL8*1H, 2H LZFSTL8*1H, 2H EZFSDTL*1H LZFSDTL*1H INSTALLATION AND USE MANUAL Manual de instalación y uso Manuel d’installation et utilisation EZTL™ & LZTL™ Series Versatile Bi-Level Water Coolers EZTL™ & LZTL™ Serie versátil bi-nivel enfriadores de agua EZTL™ & LZTL™ Série versatile refroidisseurs d’eau à deux niveaux Versatile Cooler Models EZSTL8L and LZSTL8L configuration as shipped Versatile Cooler Models EZSTL8L and LZSTL8L alternate installation PAGE 1 1000003116 (Rev.
PAGE 2
EZFSTL8*1H, 2H LZFSTL8*1H, 2H EZFSDTL*1H LZFSDTL*1H Note: Danger! Electrical shock hazard. Disconnect power before servicing unit. Nota: peligro! Peligro de descarga eléctrica. Desconecte antes de reparar la unidad Remarque : Danger ! Risque de choc électrique. Débrancher avant de réparer l’appareil. Uses HFC-134A refrigerant Usa refrigerante HFC-134A Utilise du fluide frigorigéne HFC-134A 5, 14 14 1 1 23 26 12 9 11 29 3 16 4 See Fig.
PAGE 3
PAGE 3 17 7/16" 443mm ‰ 13 15/16" 354mm 7/8" 22mm 2" 51mm 6 3/8" 162mm F B FIG.
PAGE 4
1000003116 (Rev. B - 08/18) E PAGE 4 2" 51mm F D ALT.
PAGE 5
EZFSTL8*1H, 2H LZFSTL8*1H, 2H EZFSDTL*1H LZFSDTL*1H Versatile Wrapper and Trim Kit Installation Instructions Left Hand Wrapper (High Side) 1) Remove existing wrapper by removing the (4) screws from bottom. 2) Screw trim piece to wrapper with (2) screws (provided) 3) Re-install wrapper with (4) screws. 4) Dispose of unused Right Hand Wrapper (Low Side) 1) Remove existing wrapper by removing the (4) screws from bottom. 2) Clip cover plate, sliding until plate sits flush with the wall.
PAGE 6
EZFSTL8*1H, 2H HANGER BRACKETS INSTALLATION 1) Remove hanger brackets fastened to back of cooler by removing one (1) screw. 2) Mount the hanger brackets as shown in Figure 2 or 3. NOTE: Hanger Bracket MUST be supported securely. Add fixture support carrier if wall will not provide adequate support. Anchor hanger securely to wall using all six (6) 1/4 in. dia. mounting holes. INSTALLATION OF COOLER 3) Hang the cooler on the hanger bracket.
PAGE 7
EZFSTL8*1H, 2H LZFSTL8*1H, 2H EZFSDTL*1H LZFSDTL*1H Service Instructions Lower and Upper Shroud 10 To access the refrigeration system and plumbing connections, remove four screws from bottom of cooler to remove the lower shroud. To remove the upper shroud for access to the pushbars, regulator, solenoid valve or other components located in the top of the unit, remove lower shroud, disconnect drain, remove four screws from tabs along lower edge of upper shroud, unplug two wires and water tube.
PAGE 8
EZFSTL8*1H, 2H LZFSTL8*1H, 2H EZFSDTL*1H LZFSDTL*1H 10 6 Basin Estanque Bassin Locknut Tuerca de Fijación Écrou de Blocage BUBBLER DETAIL DETALLE DEL GRIFO DETAIL DU BARBOTEUR VANDAL RESISTANT BUBBLER DETAIL DETALLE DEL GRIFO RESISTENTE AL VANDALISMO DESCRIPTION DU BARBOTEUR RESISTANT AU VANDALISME FIG. 5 NOTE: FIG. 6 When installing replacement bubbler and pedestal, tighten locknut only to hold parts snug in position. Do Not Overtighten.
PAGE 9
EZFSTL8*1H, 2H LZFSTL8*1H, 2H EZFSDTL*1H LZFSDTL*1H 115V PARTS LIST/ 115V LISTA DE PIEZAS/ 115V LISTE DES PIÈCES ITEM PART NO. NO.