Installation Guide

Elkay

2222 Camden Court

Oak Brook, IL 60523

elkayusa.com

(9/13) PART NO. 0000000737

FLR-DRAIN

No Caulk Shower Drain

NOTE: BEFORE BEGINNING INSTALLATION, FOLLOW ALL LOCAL PLUMBING AND BUILDING CODES.

INSTALLATION

1. Unscrew and remove brass locknut, paper friction washer and rubber sealing washer.

Remove strainer from drain with a screwdriver.

2. From the top side of the shower, loosen (do not remove) the compression nut in the drain

body and apply a bead of silicone around the underside of drain top.

3. Push the drain body firmly down against the shower floor.

4. From below the shower, slide rubber gasket then paper friction washer into drain body and

slide over pipe. Make certain that the beveled end of the gasket is facing up and is flush with pipe

surface. Be sure there are no obstructions and that the sealing washer makes clean, even

contact with the bottom of the shower floor. Engage the locknut and tighten up against washer

stack.

5. From the top side of the shower, clean shower floor of any excess silicone.

6. From below the shower, install the pipe into the drain body through the compression gasket

until the pipe is flush with the top of the gasket.

7. From the top side of the shower, tighten compression nut with wrench. Adapter bar provided.

8. Allow 24 hours for silicone to cure and then check for leaks.

9. When the installation is complete, remove the adhesive cover from the strainer.

* Designed to work with 2” schedule 40 plastic pipe only.

a. Turn water on in shower and from below shower floor, check the drain area for leaks

concentrating on:

i. [1] the area between pipe and compression gasket

ii. [2] between shower floor and sealing washer

b. If a leak occurs in area [1], use the wrench to tighten the compression nut.

c. If a leak occurs in area [2], tighten outer locknut.

Locknut

Compressi on nut

Compressi on gasket

Paper friction

washer

Rubber sealing

washer

Apply si licone bead

Shower fl oor

Strainer