Installation Sheet

CAULKING
COMPOUND
COUNTER TOP
SINK
UNDER SIDE OF SINK
COUNTER TOP
DRAW OUTLINE
AROUND SINK
5/16” MINIMUM
OUTLINE OF
SINK
COUNTER TOP
COUNTER TOP
1 Position sink upside
down on countertop.
2 Draw line 5/16” inside outline of sink.
3 Cut on inside line. Cut straight front-to-back
and left-to right.
4 Apply caulking compound around cutout on
countertop top surface.
5 Mount faucet and drain(s) in place on sink and
tighten per manufacturer’s instructions.
6 Set sink in cutout.
7 Preassemble clamps, screws and plastic pads.
8 From underside – place clamp in center along
each side and hand tighten to hold sink in place.
Fasten balance of clamps along edges spaced
approximately 3” from each end, and equally
along front, back and sides.
9 From the top – check seal between sink edge
and countertop. Adjust clamps if necessary.
10 Lightly tighten clamps evenly with screw driver
or socket wrench until sink is perfectly tight to
countertop.
CAUTION: Do not over tighten clamps.
MAXIMUM CUTOUT SIZES SHOULD BE:
Sink Size Cutout Size
Cutout
Corner
Radius
33" x 22"
33” x 21-1/4”
25” x 22”
25” x 21-1/4”
32-3/8" x 21-3/8"
32-3/8" x 20-5/8"
24-3/8" x 21-3/8"
24-3/8" x 20-5/8"
1-1/2"
1-1/2"
1-1/2"
1-1/2"
1-1/2"
DAYTON TOP MOUNT
STAINLESS STEEL SINK
CAULK
SINK
PLASTIC
PAD
CLAMP
DETAIL OF CLAMP DEVICE