Installation Guide

[phone] 5 Elkay Manufacturing Company
1000005232 (Rev. C - 05/19) Built-in Filtered Water Dispenser
WARNING
Contacting live electrical wiring with
power tools or hand tools can cause
serious injury or death.
• Make sure all related circuit breakers are turned
OFF.
• Test for live circuits or wiring inside any wall
where installation of the product requires cutting
into a wall.
Prior to any maintenance, make sure the
unit is disconnected from the power
source and the circuit breaker is turned
OFF.
Prior to installation, test for live circuits or
wiring inside the wall before cutting or
drilling into the wall. Before working near
any electrical circuit or wiring, remove all power and
use a circuit tester to verify the power has been
disconnected. Contact with live electricity can cause
serious bodily injury and in some cases death.
CAUTION
These cautions indicate a potentially hazardous
situation which, if not avoided, may result in minor
or moderate injury. Follow all instructions related to
installation and/or maintenance of this product.
Tripping Hazard
Personal injury can result from tripping over
power cords, tools, or other installation items.
DO NOT leave items laying around the work area.
Cutting Hazard
The installation of this product requires using
power tools.
Keep hands away from the cutting edge of any
tool used in the installation of our product.
Placing ngers in or around the cutting blades
could result in serious personal injury.
Use Proper Tools
Always use proper tools which are in good
working condition during the installation of the
product.
2.4 Property Damage
NOTICE
Inspect Before Cutting
Make sure no electrical wiring or plumbing is
present before cutting into a wall.
3. Installation Preparation
NOTICE
The installation of this product
requires electrical and
plumbing connections that use specic skills and
knowledge. If you are unsure or not qualied to make
these connections, consult a qualied plumber,
electrician, or installer for this installation.
Professional installation is recommended.
3.1 General Information
1. This water dispenser is designed for indoor use only
and should not be installed outdoors or in a humid
environment. This water dispenser should not be
installed on exterior walls.
NOTICE
A water supply pressure below
40 psi will result in decreased
water ow through the unit and damage to the
product. A pressure above 105 psi will also cause
damage to the product.
2. Make sure the water supply pressure to the product
is between 40 and 105 psi. The water dispenser with
lter requires 40 psi minimum water pressure.
3. Use care when opening and removing the packaging
to prevent damage to the product.
a. Inspect the product for any shipping damage and
report it immediately to the location of purchase.
Installation of a damaged product will void the
warranty.
b. Conrm that all parts have been included for the
proper installation of this product. Contact the
location of purchase if damaged parts are found.
NOTICE
Make sure no electrical wiring,
potable water inlet pipes, or
drain water outlet pipes will be damaged during
installation of the product. Damage to any of these
items can cause electrical damage, re, and/or water
damage.
4. Shut off the water supply source and disconnect
power to the electrical circuit being used to operate
the product before starting the installation.