Instructions / Assembly
(630) 574-8484 Elkay Manufacturing Company
1000005449 (Rev. E - 04/23)
Page 13
4.4.4 Installing Remote Filter
Note: The filter unit is installed remotely, up to 15 feet
away from the water dispenser. The filter can also
be installed in conjunction with a remote chiller. If
installing a chiller, first review section 4.5 to ensure
proper preparation is taken.
1. Once the water lter is installed, remove lter head
from the lter box as shown below.
2. Securely mount the lter head in the desired
remote location within 15ft of the water dispenser.
One recommendation is to install the lter head by
screwing it into a stud on the back side of a wall.
a. Remove the short 3/8" copper inlet water tube.
b. Remove the NFC card.
c. Remove the four screws that hold the bracket to
the lter head.
c.
a.
b.
d. Screw the bracket to a wall stud, then reassemble
the lter head, NFC card, and inlet water tube.
Note: If desired, you can install the filter into the filter
head now.
3. Connect a 3/8" water supply line, copper or plastic, to
the quarter-turn shutoff valve at the remote location.
4. Connect a 1/4 inch insulated water line, copper or
plastic, to the outlet connector of the lter.