Installation Sheet

1
2
Make connections to water lines. Use 1/2" IPS
faucet connections (1) Use wrenches to tighten
connections. Do not overtighten.
Important: After installation is completed, remove
aerator. Turn on water supply and allow both hot
and cold water to run for at least one minute each.
While water is running, check for leaks. Replace
aerator.
Place gasket (1) on bottom of new faucet. Place
faucet through mounting holes in sink. Secure
faucet to sink using mounting nuts (2) provided.
Shut off water supply at angle stop. Remo
ve old
faucet.Clean sink surface in preparation for new
faucet.
1
STEPS:
WARNING: Please carefully read and properly follow the instructions for installation found in this manual.