Installation Sheet

ManualsBrandsElkay ManualsPopular CollectionsElkay EZH20 26" Floor Mounted Outdoor Bi-Level Bottle Filler Combo Station and Pet Station with Freeze Resistance - Vandal Resistant Bubbler

PAGE 1

4420DBBFFR_FTN LK 4420DBBFFR_FTN

98880C (Rev. C - 12/15)

INSTALLER

Owners Manual

4420 Bottle Filler Freeze Resistant Tubular Fountain & Pet Fountain

with 98837C Dual Valve Control Assembly

MODEL 4420BF1LDBFRMODEL 4420BF1UDBFR

4420DBBFFR Fountains are among the easiest to install Fountains on the market today. To assure

you install these models easily and correctly, PLEASE READ THESE SIMPLE INSTRUCTIONS

BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE

WITH PLUMBING, ELECTRICAL, AND OTHER APPLICABLE CODES. After installation, leave these

instructions with the Fountain for future reference.

Summary of content (8 pages)

PAGE 1
4420DBBFFR_FTN LK 4420DBBFFR_FTN Owners Manual 4420 Bottle Filler Freeze Resistant Tubular Fountain & Pet Fountain with 98837C Dual Valve Control Assembly MODEL 4420BF1UDBFR MODEL 4420BF1LDBFR INSTALLER 4420DBBFFR Fountains are among the easiest to install Fountains on the market today. To assure you install these models easily and correctly, PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE INSTALLATION.
PAGE 2
4420DBBFFR_FTN LK4420DBBFFR_FTN INSTALLATION INSTRUCTIONS IMPORTANT ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON IMPORTANT! INSTALLER PLEASE NOTE. THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE BUILDING.
PAGE 3
4420DBBFFR_FTN LK 4420DBBFFR_FTN SITE PREPARATION DETAIL FOR THE 4420BFDBFR FTN. WHEN USING 98837C OR 98838C DUAL VALVE CONTROL ASSY. 29" 737mm 8 - O .500" HOLES EQUALLY SPACED ON TWO O 12.00" B.C. O 14" 356mm (2 PL) 22" 559mm G PVC COLUMN CENTERED BETWEEN MOUNTING BOLT HOLES H F O 10" 254mm 3" 76mm 14 9/16" 371mm 2 7/8" 73mm A 64" 1626mm 44" 1118mm 19" 483mm H 34 11/16" 881mm ORIFICE HEIGHT G A F J 8" 203mm 4" 102mm E C CONCRETE SLAB FILL LINE 12" 305mm MIN.
PAGE 4
98880C (Rev. C - 12/15) FIG. 3 PAGE 4 A B FINISHED FLOOR 19" 483mm LEGEND A = ACCESS PANEL ( 8" X 10" ) B = REMOVABLE BOTTOM COVER 8" 203mm 40 5/16" 1025mm 41 11/16" 1059mm ORIFICE HEIGHT O 14" 356mm (2 PL) 26" 660mm 8 - O.500" HOLES EQUALLY SPACED ON TWO O12.00" B.C.
PAGE 5
PAGE 5 6 9/16" 167mm 30" 762mm 8" 203mm 64" 1626mm 44" 1118mm 14 9/16" 371mm LEGEND A = ACCESS PANEL ( 8" X 10" ) B = REMOVABLE BOTTOM COVER A A O 10" 254mm O 14" 356mm (2 PL) 8 - O.500" HOLES EQUALLY SPACED ON TWO O12.00" B.C.
PAGE 6
4420DBBFFR_FTN LK4420DBBFFR_FTN 22 14 & 23 2 23 23 15 16 14 & 22 18 14 & 23 17 & 29 8 15 22 20 10 ARM ONLY 11 9 ADJUST BUBBLER HEIGHT FROM BELOW Dual Valve Assy. (Item 28) W/Regulator P/N 98837C For use on models 4420BF1LDBFR and 4420BF1UDBFR (Tubing Not Included) FIG. 5 98880C (Rev.
PAGE 7
4420DBBFFR_FTN LK 4420DBBFFR_FTN 13 4 26 12 1 26 23 15 26 30 19 7 26 23 6 22 15 32 21 31 3 21 5 22 34 25 33 35 27 24 24 or 25 FIG. 6 PAGE 7 98880C (Rev.
PAGE 8
4420DBBFFR_FTN LK4420DBBFFR_FTN TROUBLE SHOOTING Insufficient Flow: Check that the shut-off valve is wide open. Verify minimum 20 PSI supply pressure. Clean inlet strainer screen located in the valve body. Clean rubber orifice in flow control located below frost line in bushing between barb fitting and valve. No Flow: Check for leaks in the air tubing going from the push button to the valve. Make sure the air tubing compression nut is hand tight. Disconnect air tube from push button.