Installation Instructions for Wall Mount, Deck Mount and Pre-rinse Faucets SAVE FOR END USER ELKAY • 2222 CAMDEN COURT • OAK BROOK, IL 60523 USA
WALL MOUNT ASSEMBLY General Instructions • Turn off the water supply at the main source. • Hand tighten all parts prior to tightening with wrench. Do not force parts together. • Handle plated surfaces with care, being careful not to scratch with tools. • Wall mount faucets have a 1/2" I.P.S. female flanged inlet. • For easier assembly, you may purchase as an accessory, the LKMK462 mounting kit (see Figure 2).
Assemble Faucet to Flange 1. Carefully orient, mount and hand tighten the faucet to the WALL BRACKET BASE ATTACH WITH SCREWS two flanges. Be sure to include (NOT INCLUDED) the washers provided. 2. Use wrench to tighten flange against backsplash. (Maintain alignment of faucet or spout to APPROX. sink while tightening.) 15-1/4" 3. Wrench tighten flanges to faucet body, tighten flange against backsplash. 4. Make sure drain is attached and turn on water supply – being sure to check for leaks.
DECK MOUNT ASSEMBLY General Instructions • Turn off the water supply at the main source. • Hand tighten all parts prior to tightening with wrench. Do not force parts together. • Handle plated surfaces with care, being careful not to scratch with tools. • All deck mount faucets and spouts come complete with compression nut, cone washer and friction ring for 1/2" O.D. tube. FAUCET BASE SINK DECK SHANK RUBBER WASHER LOCK WASHER LOCK NUT FIGURE 4 Assemble Base to Sink Deck 1.
TO REPLACE CARTRIDGE General Instructions • Turn off the water supply at the main source. • Handle plated surfaces with care being careful not to scratch with tools. • When assembling faucet after replacement, hand tighten all parts prior to tightening with wrench. Do not force parts together. For LK500C and LK945 Models 1. After shutting off water supply, move handles to open position to relieve built up pressure. 2. Remove handles from cartridge stem. 3. Remove handle nuts if applicable. 4.
PRE-RINSE ASSEMBLY General Instructions • Turn off the water supply at the main source. • Hand tighten all parts prior to tightening with wrench. Do not force parts together. • Handle plated surfaces with care, being careful not to scratch with tools. • All wall mount faucets have a 1/2" I.P.S. female flanged inlet. • For easier assembly, you may purchase as an accessory, the LKMK462 mounting kit (see Figure 2). For spout model LK395A a mounting kit is included. Assemble Flanges to Backsplash 1.
6. Assemble wall bracket (see Figure 8). 7. Assemble hose, spring, and spray head (see Figure 9). 8. Make sure drain is attached and turn on water supply – being sure to check for leaks. Tighten with wrench where needed. SPRING RETAINER WALL FERRULE WALL BRACKET BASE Determine correct length of Support Rod from Wall to Riser Pipe. Cut Rod to approximate size. Affix Wall Bracket Base securely to Wall. Install Compression Nut and Brass Ferrule and tighten securely.
IMPORTANT END USER INFORMATION Care and Cleaning Instructions Your Elkay faucet has been constructed of the finest materials, however, certain precautions must be taken to maintain the lustrous decorative finish. Do not use abrasive cleansers or harsh chemical cleansers on this product which could damage the finish. A warm water wash with a wipedown using a soft cloth will generally remove dry water spots. Never use alcohol or other organic solvents.
