Installation Guide

• Turn off the water supply at
the main source.
• Hand tighten all parts prior
to tightening with wrench.
Do not force parts together.
• Handle plated surfaces with
care, being careful not to
scratch with tools.
• Wall mount faucets have a
1/2" I.P.S. female flanged
inlet.
• For easier assembly,
you may purchase
as an accessory, the
LKMK462 mounting kit
(see Figure 2).
BACKSPLASH
SPOUT
BODY
WASHER
MOUNTING KIT IS INCLUDED WITH LK395A
1/2" COPPER
SWEAT INLET
1/2" NIPPLE
LOCK NUT
LOCK WASHER
FLANGE
General Instructions
FIGURE 1
1. Apply teflon tape or pipe
joint compound to the
supply line nipples.
2. Place nipples through
holes in backsplash.
3. Assemble each flange to
one nipple, then the other.
4. Using the optional
LKMK462, apply
in order behind the back
-
splash: rubber washer,
lock washer, lock nut and
elbow (see Figure 2).
5. Thread flange loosely
against wall or backsplash.
SINK/
BACKSPLASH
WASHER
LOCK WASHER
1/2" I.P.S.
BY 1/2"
COPPER
SWEAT
ELBOW
TIGHTEN
LOCK NUT
SHOWN WITH OPTIONAL 90°
MOUNTING KIT NO. LKMK462
FAUCET
BODY
FLANGE
NIPPLE
FIGURE 2
Assemble Flanges to Backsplash
WALL MOUNT ASSEMBLY