Installation Guide

DECK MOUNT ASSEMBLY
• Turn off the water supply at
the main sour
ce.
•
Hand tighten all parts prior
to tightening with wrench.
Do not for
ce parts together.
•
Handle plated surfaces
with care, being careful not
to scratch with tools.
• All deck mount faucets and
spouts come complete
with compression nut, cone
washer and friction ring for
1/2" O.D. tube.
General Instructions
FAUCET
BASE
SINK
DECK
SHANK
RUBBER
WASHER
LOCK
WASHER
LOCK NUT
FIGURE 4
1. Apply teflon tape or pipe
joint compound to the
threads on the shank(s).
2. Apply a small amount of
plumbers putty or sealant
along faucet base.
3. Place shank(s) through
holes in deck.
4. Apply in order: rubber
washer, lock washer and
lock nut (see Figures 4
and 5).
5. Use wrench to tighten lock
nut against deck of sink.
(Maintain alignment of
faucet or spout to sink
while tightening.)
6. Attach supply lines.
7. Make sure drain is attached and turn on water supply – being sure to check for
leaks. Tighten with wrench where needed.
Assemble Base to Sink Deck
SPOUT
BASE
SINK DECK
RUBBER
WASHER
LOCK
WASHER
LOCK NUT
SHANK
FIGURE 5