Installation Sheet

• Elkay is not responsible for improper drain installations.
• Elkay is not responsible for the sink if damaged during installation.
• Follow all local plumbing and building codes.
• Inspect drain for damage prior to beginning installation.
Required Tools (not included)
Installation
Attention Installer:
Apply plumber’s putty or sealant to the top
of the sink drain flange area. Place drain
body in the the drain opening of the sink.
From the underside of the sink, slide the
rubber gasket over the bottom of the drain
body till it’s flush with the bottom of the sink.
Slide the drain housing over the bottom of the
drain body till it’s flush with the rubber gasket
and the bottom of the sink. Thread on the lock
nut until tight with the housing.
Place the plastic washer inside of the tail piece.
Slide the coupling nut over the tail piece.
Thread on the coupling nut onto the drain
housing until tight.
Installation Instructions:
Drains
1333 Butterfield Road, Suite 200 | Downers Grove, IL 60515 | elkay.com ©2019 Elkay Manufacturing Company (8/19) 1000005235.pdf
1
2
3
Wipe away any excess plumber’s putty from
the sink with a rag.
Place strainer basket into the drain body.
*Note: Drain bodies and strainer baskets
may vary depending on models. Some
models may come with a strainer grid, in
place of a strainer basket, that will need to
be screwed into the drain body.
**Model shown is a LK99.
4
PUTTY
Plumber’s putty
(Not furnished)
Rubber gasket
Rubber gasket
Strainer basket
Drain body
Drain housing
Drain housing
Lock nut
Lock nut
Drain body
Tail piece
Tail piece
Plastic washer
Plastic washer
Coupling nut
Coupling nut