Installation Manual

ManualsBrandsElkay ManualsPull-OutSingle Hole Kitchen Faucet with Pull-Down Spray and Forward Only Lever Handle: Black Stainless

CARTRIDGE REPLACEMENT

Loosen cartridge nut (1) by turning it

counter-clockwise and lift out the cartridge (2). Insert

new cartridge. Reinstall the handle.

Shut off water supply. With valves in "closed" position,

remove handle (1) from handel seat (3). Loosen the set

screw (2) and unscrew the cap (4) from the cartridge

nut (5).

Congratulations on your purchase of an Elkay product.

Although your product is extremely durable, attention should

be given to the care, cleaning and maintenance of this

product. Cleaning agents and abrasives may cause damage,

which may result in oxidation and discoloration.

By following these simple guidelines for proper care and

cleaning, it will give you years of enjoyment:

TO CLEAN: Simply wipe gently with a damp cloth and blot dry

with a soft towel. A common rule of thumb is: when you dry off,

dry off your product.

· Avoid build-up of soap, toothpaste or mineral deposits, as

these tend to have an adverse effect on the appearance of

the product.

· NEVER use cleaning products of any kind on this product -

especially those containing ammonia, bleach or alcohol - or

those with any form of abrasive.

CARE AND CLEANING INSTRUCTIONS

FOR CARE AND MAINTENANCE:

·The water in certain areas of the world can be very caustic -

standing water around the product can cause damage. Be

sure to remove standing water with a dry, soft cloth as soon

as possible.

·For polished brass finishes, as often as once a week, you

can apply a paste wax or special, non-abrasive, brass

coating (DO NOT APPLY POLISH).

·Before applying a protective coating, gently brush the entire

fixture using a soft tooth brush. This will remove any dirt or

deposit build-up.

·These simple steps will add temporary protective coating to

your faucet and extend the life of the finish.

Failure to follow care and cleaning will void your warranty.

For additional information, please visit elkayusa.com .

Important: after installation is

completed, turn on hot and cold water

supplies. Check for leaks. Pull the

hose assembly out of the spout and

remove the spray head by unscrewing

it from the hose counterclockwise. Be

sure to hold the end of the hose down

into the sink and turn the faucet on to

the warm position where it mixes hot

and cold water. Flush water lines for

one minute. Check for leaks.

Re-tighten any connections if

necessary, but do not overtighten.

Reinstall spray head by hand

tightening it back onto the spray hose.