Installation Guide
WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
From underneath the sink,align block ①
and tabs ② on quick connects.Push quick
connect housing firmly upward and snap
onto receiving block.Pull down moderately
to ensure connection has been made. If it
is necessary to remove quick connect,
squeeze tabs on hose between index
finger and thumb, then pull down to
disconnect.
1
Important: after installation is completed,
turn on hot and cold water supplies.
Remove aerator ①. Turn faucet handle to
the warm position where it mixes hot and
cold water. Flush water lines for one
minute. Check for leaks.Retighten any
connections if necessary.Reinstall the
aerator tightly.
1
Place faucet through the hole in top of
sink. From underside,assemble rubber
washer ①,metal washer ② and nut ③
onto long shank ④ and tighten nut ③.
Firmly tighten the nut ③ to metal washer
②. Do not overtighten.
Make connections to water lines with 3/8"
female compression supply hoses ①.
If additional hose length is needed, attach
included 1/2" MIP thread adaptors ② to
supply hoses ①. Use 1/2" I.P.S. faucet
connections ③ or coupling nuts ⑤ with 3/8"
O.D.ball-nose riser ④ to make connections
to water lines. Use wrenches to tighten
connections. Do not overtighten.
3
2
5
4
Shut off water supplies.Clean sink surface.
Place washer ② and flange ① on the sink
③.If you do not use flange,please use
escutcheon ④ and gasket ⑤ to replace
flange and washer.
1
3
2
1
STEPS:
Ø 1 3/8''
Ø35mm
4
5
1
2
3
4
2