Installation Instructions

ManualsBrandsElkay ManualsDrinking FountainsElkay 7.5 GPH ADA Wall Mount Bi-Level Soft Sides Filtered Cooler with Cane Apron

PAGE 1 97299C (Rev. SIQ - 5/13)

NOTE: Performance will vary depending on local water conditions. While testing was

performed under standard laboratory conditions actual performance may vary.

Instructions For Installing Replacement Filters

1. Turn off water supply; dispense water to relieve pressure

2. Turn used filter counterclockwise 1/4 turn to remove from filter

head.

3. Remove cap from new filter and use to seal used filter.

4. Insert new filter into existing filter head and turn fully clockwise.

5. Turn on water supply and run a minimum of two gallons of

water through the filter to purge air and fine carbon particles

from filter. Also run water through glass filler (if provided)

LIMITED WARRANTY

The ELKAY WaterSentry

VII is warranted to be free from defects in material and

workmanship for a period of one year from the date of installation. Warranty is limited to

repair or replacement of defective component.

Your Authorized Representative

Buyer

Seller

Capacity

Flow Rate

Temperature

1500 Gallons

1 Year Maximum

1.5 GPM

40-120° F (5-50° C)

RECOMMENDED USE CONDITIONS

Maximum Pressure 105 PSI (7.4 Kg/cm

)

Minimum Pressure 20 PSI (1.4 Kg/cm

)

Elkay

WaterSentry

VII

Lead, Aesthetic Chlorine Taste & Odor & Particulate Class I Reduction

Filter Part No. 51299C FOR EWF172 - WaterSentry

VII

FOR COMMERCIAL USE ONLY

PERFORMANCE DATA SHEET

IMPORTANT NOTICE: Read this Performance Data Sheet and compare the capabilities of

this unit with your actual water treatment needs. It is recommended that, before purchasing

a water treatment unit, you have your water supply tested to determine your actual water

treatment needs.

NOTICE: Do not use with water that is microbiologically unsafe or of unknown quality

without adequate disinfection before or after the system.

CAUTION: Use on cold water line only. Do not allow installed filter to freeze.

Note: This system and installation shall comply with applicable state and local regulations.

The Elkay WaterSentry

VII filter is certified by WQA to NSF/ANSI 42 and 53 for the

reduction of Aesthetic Chlorine, Taste and Odor, Particulate Class I, and Lead, as verified and

substantiated by test data.

Summary of content (2 pages)

PAGE 1
Elkay WaterSentry® VII ® Lead, Aesthetic Chlorine Taste & Odor & Particulate Class I Reduction Filter Part No. 51299C FOR EWF172 - WaterSentry® VII FOR COMMERCIAL USE ONLY PERFORMANCE DATA SHEET ® The Elkay WaterSentry VII filter is certified by WQA to NSF/ANSI 42 and 53 for the reduction of Aesthetic Chlorine, Taste and Odor, Particulate Class I, and Lead, as verified and substantiated by test data.
PAGE 2
Performance Test Conditions NSF/ANSI 42 NSF/ANSI 53 Aesthetic Chlorine Particulate - Class I Taste and Odor Reduction Lead Reduction Capacity 1500 Gallons (5678 l) Flow Rate 1.5 gpm (2.8 l/m) Pressure 60 psi (4.2 kg/cm2) Temperature 68-70o F (20-21o C) This system has been tested according to NSF/ANSI 42 and 53 for reduction of the substances listed below.