CuVerro V Information Sheet

This product is made out of a copper surface that
continuously kills bacteria left behind by dirty hands,
killing more than 99.9% of bacteria* within 2 hours.
Laboratory testing has shown that when cleaned regularly this surface:
Kills greater than 99.9% of bacteria* within two hours, and continues to kill 99% of
bacteria* even after repeated contamination
Delivers continuous and ongoing antibacterial* action, remaining effective in killing
greater than 99.9% of bacteria* within 2 hours.
Helps inhibit buildup and growth of bacteria* within 2 hours of exposure between
routine cleaning and sanitizing steps.
Kills greater than 99.9% of Gram-negative and Gram-positive bacteria* within 2 hours of exposure.
Continuously reduces bacterial* contamination, achieving 99.9% reduction within 2 hours of exposure.
*Staphylococcus aureus, Enterobacter aerogenes, Methicillin-Resistant
Staphylococcus aureus (MRSA), Escherichia coli O157:H7, and Pseudomonas aeruginosa.
DIRECTIONS FOR USE:
It is violation of Federal Law to use this product in a manner inconsistent with its labeling
PROPER CARE AND USE: Clean and sanitize according to standard practice. Healthcare
facilities must maintain the product in accordance with infection control guidelines. The
use of this surface is a supplement to and not a substitute for standard infection control
practices; users must continue to follow all current infection control practices, including
those practices related to cleaning and disinfection of environmental surfaces. This surface
has been shown to reduce microbial contamination, but does not necessarily prevent
cross contamination.
This surface may be subject to recontamination and the level of active bacteria at any
particular time will depend on the frequency and timing of recontamination and cleanliness of
V
Antimicrobial Copper Surface
the surface (among other factors). In order to have proper antimicrobial effect, this product
must be cleaned and maintained according to the directions for use.
DO NOT WAX, PAINT, LACQUER, VARNISH, OR OTHERWISE COAT THIS PRODUCT.
Routine cleaning to remove dirt and filth is necessary for good sanitation and to assure the
effective antibacterial performance of this surface. Cleaning agents typically used for
traditional hard, non-porous touch surfaces are permissible. The appropriate cleaning agent
depends on the type of soiling and the measure of sanitization required. Normal tarnishing or
wear of this product will not impair the antimicrobial effectiveness.
NOT APPROVED FOR DIRECT FOOD CONTACT OR FOOD PACKAGING USES.
Items exposed to outdoor environmental conditions are not representative of indoor laboratory
test conditions, and therefore, may impart reduced efficacy if not cleaned when visibly soiled.
STORAGE AND DISPOSAL: Dispose of by recycling or put in trash.
WARRANTY STATEMENT: If used as intended this product is wear-resistant and the durable
antibacterial properties will remain effective for as long as the product remains in place
and is used as directed.
OB-0005-1104
EPA Est No.
Manufactured by:
Elkay Mfg. Co.
2700 S. 17th Ave.
Broadview, IL 60155 087150-IL-002
74180724
Global Brass and Copper, Inc.
427 N. Shamrock St.
East Alton, IL 62024
www.CUVERRO.com
1-877-311-CUVERRO(2883) EPA Reg No 85353-5