Specification Sheet

GENERAL
Fully exposed dual height stainless steel fountains have
recessed in-the-wall refrigeration system and stainless steel
grill. Stainless steel tubular support arms incorporate unique
recess to be integrated with basins. All stainless steel
polished to lustrous satin finish with high shined outer edge.
Fountains have contoured basins to minimize splashing.
Flexi-Guard
®
safety bubblers and easy to operate, fully func-
tional vandal-resistant front push button. Flow regulator pro-
vides constant stream from 20 to 105 psi water pressure.
NOTE: Minimum 40 psi supply line pressure required in spe-
cial circumstances where both sides of bi-level are in use
simultaneously to ensure adequate stream height. Use of
water filtered unit in this situation is not recommended.
THIS WATER COOLER COMPLIES WITH THE
REQUIRE-
ME
NTS OF A.D.A. (AMERICANS WITH DISABILITIES ACT)
WHEN PROPERLY INSTALLED. UNIT IS COMPLIANT IF
INSTALLED IN AN ALCOVE AND IS ALSO COMPLIANT
WHEN MOUNTED ON AN EXPOSED WALL IF A WING
WALL IS LOCATED ON THE LEFT SIDE OR IF AN LKAPR1
APRON IS INSTALLED UNDER THE UPPER UNIT.
NO LEAD DESIGN
THIS WATER COOLER COMPLIES WITH THE LEAD-FREE
DEFINITION IN THE SAFE DRINKING WATER ACT OF 1986
AND LEAD CONTAMINATION CONTROL ACT OF 1988.
Elk
ay Water Coolers are manufactured with a waterway sys-
tem utilizing copper components and completely lead-free
material. These waterways have no lead because all lead
materials, such as leaded brass, have been removed. All
joints are brazed using silver solder only. No lead solder is
permitted. A strainer with an easily cleanable screen is pro-
vided to allow trapping and convenient removal of waterborne
particulate of 140 microns and larger prior to their entry into
the water cooler.
WATERSENTRY
®
FILTER SYSTEM
Elkay Water Coolers are equipped with the WaterSentry VII
Filter System. Tested to NSF/ANSI Standard 53 yields a
reduction of soluble and in-soluble lead content to less than
0.015mg/l. This translates to lead reduction levels of 93% to
99%. Class 1 particulate reduction as tested per NSF
/ANSI
42. Removes over 97.5% of free available chlorine which pro-
vides Class 1 performance as tested to NSF/ANSI 42.
Provides taste and odor improvement.
Co
oling Unit:
Temperature Control: Enclosed adjustable thermostat is fac-
tory preset. Requires no adjustment other than for altitude
requirements.
Refrigerant Control: Refrigerant HFC-134a is controlled by
accurately calibrated capillary tube for positively trouble-free
performance.
CONSTRUCTION
Fountain Body: #18 gauge, type 304 nickel bearing stainless
steel polished to a lustrous satin finish with high shined outer
ed
ge. Contoured basin offers large strike area to minimize
splashing. #16 gauge, type 304 tubular support arms incor-
porate unique recess to accept basins. Fully functional
vandal-resistant push buttons are easy to operate.
Exclusive Flexi-Guard
®
Safety Bubbler: Innovative design
utilizes an infused anti-microbial pliable polyester elastomer
to prevent accidental mouth injuries. Flexes on impact,
then returns to original position. Strong. Abrasion-resistant.
Anti-sweat.
Front Panel Grill: Made of type 304 stainless steel, polished
to a uniform Elkay satin finish. Removable louvered ventilat-
ing grill encloses refrigeration unit and plumbing.
Wall Mounting Frame: MF200 frame furnished with each
unit. Frame allows flush mounting to finished wall.
Protected by Elkay’s 5 Year Limited Warranty on
the refrig-
eration system of the unit.
Elkay Pressure-Type Water Coolers are designed to operate
on 20 psi to 105 psi supply line pressure. If inlet pressure is
above 105 psi, a pressure regulator must be installed in the
supply line. Any damage caused by reason of connecting this
product to supply line pressures lower than 20 psi or higher
than 105 psi is not covered by the warranty.
ST
ANDARDS
Model LRPB(M)28K
CAPACITIES CHART
*GPH of 50°F Drinking Water
Full Glass Ship.
Model Base
Room Temperature °F
Rated Load Filler Pre- Wt.
Number Rate 70°F 80°F 90°F Watts Amps Option Cooler Lbs.
LRPB(M)28K 7.5 8.6 8.1 7.5 370 4.0 No No 141
No Lead Two-Level SwirlFlo
®
with WaterSentry
®
VII Filter System
Barrier-Free Access
Model LRPB(M)28K
®
®
SPECIFICATIONS
Elkay
2222 Camden Court
Oak Brook, IL 60523
Printed in U.S.A.
©2015 Elkay
(Rev. 12/15) 12-44D
elkay.com
**Based on 80°F inlet water
temperature.
Rated watts shown are based on operational (run) time, in compliance with A.R.I.
Standard 1010 conditions. Specific applications will determine the actual watts
consumed per hour. Watts consumed will be based on number of people
served per hour (usage), ambient temperatures, and inlet water temperature.
COOLING SYSTEM
Motor Compressor: Hermetically sealed, reciprocating type,
115V, 60 Hz or 230V, 50 Hz (International Model) single phase.
Sealed-in lifetime oil supply.
Condenser: Fan cooled. Fan motor is permanently lubricated.
In keeping with our policy of continuing product improvement, Elkay reserves the right to change
product specifications without notice.
This specification describes an Elkay product with design, quality and functional benefits to the
user. When making a comparison of other producers’ offerings, be certain these features are not
overlooked.
Elkay Electric Air Cooled Water Coolers are listed
by Underwriters Laboratories Inc. and comply with
both Canadian and U.S. requirements.
These units comply with A.R.I. Standard 1010.
This cooler is certified by WQA to lead-free compliance including
NSF/ANSI 61 and 372.
Combination tube-tank type. Continuous copper
tubing which is fully insulated with EPS foam that meets UL
requirements for self-extinguising material.
Model LRPB28K is designed for applications with the early
installation of the mounting frame, pre-ordered as MF200.
The fountain and water chiller are included with LRPB28K.