Installation

EZ8WSLSMC_1G EZ8WSSSMC_1G LZ8WSLSMC_1G LZ8WSSSMC_1G
Elkay Manufacturing Company [phone]
1000006137 (Rev. A - 03/21)
Page 10
6. Installation of Bottle Filler
1. Remove the two (2) mounting screws securing the
top cover to the bottle ller with 5/32" Allen wrench.
Remove the top cover.
Note: Do not discard the mounting screws, they will be
needed to reinstall the top cover.
2. Remove the wall mounting plate.
3. Place mounting plate against wall on top of the basin.
Center the mounting plate side to side with the basin.
Mark the six (6) mounting holes with a pencil.
4. Install the wall mounting plate to the wall using six
(6) 7/16" screws through the mounting holes. Use
appropriate fasteners for your wall type.
Note: To prevent scratching the basin, place a towel or
soft cloth over the entire basin.
5. Set bottle ller onto the basin. Feed the power cord and
3/8" water line through hole in the basin.
6. Feed the power cord and water line through hole on top
of the water cooler.
Top Cover
Mounting Plate