Installation

EZ8WSLSMC_1G EZ8WSSSMC_1G LZ8WSLSMC_1G LZ8WSSSMC_1G
Elkay Manufacturing Company [phone]
1000006137 (Rev. A - 03/21)
Page 12
7. Installation of Filter (LZ Only)
1. Install the lter cartridge:
• Remove the lter from the carton.
• Remove the protective cap.
• Mark the current date on the water lter label.
• Attach the lter to the lter head with label facing
outward by rmly inserting into the head and by
rotating the lter head clockwise, if required.
Note: Filter label should be readable from the front of the
filter during installation.
8. Startup
1. Make sure that there are no leaks on the drain
connections and installed as per local regulations.
2. Plug-in the water cooler and the bottle ller.
3. Once power is applied to the bottle ller, the GREEN
LED light should illuminate showing good lter status
(if equipped with lter) along with the LCD Bottle
Counter.
4. Verify proper dispensing by placing cup or any object
in front of sensor area and verify water dispenses.
Note: The first initial dispenses might have air in line
which may cause a sputter. This will be eliminated
once all air is purged from the line.
5. Check all the lines and connections for water leaks.
Repair connections if necessary.
6. Dispense at least two gallons of water to bleed o󰀨
any trapped air from supply lines and ne carbon
particles from the lter. If there are no leaks and unit
is functioning correctly, re-install the front cover by
installing the two 5/16" hex screws on the bottom side
of the cooler.
7. Upon initial startup, the plastic bottles saved indicator
panel should show several bottles saved due to the
water used to initially start up of the unit.
GREEN: 0 - 80% of Filter Life or 0 - 11
Months.
YELLOW: 80 - 100% of Filter Life or 11 - 12
Months (Whichever Comes First).
RED: 100% Plus of Filter Life or 12
Months (Whichever Comes First).