Installation Sheet

ManualsBrandsElkay ManualsDrinking FountainsElkay 36-3/4" Wall Mounted Bi-Level Drinking Station with Cooler - Vandal Resistant Bubbler

PAGE 1 0000000558 (Rev. F - 01/19)

EZSTLG8*1A, LZSTLG8*1A,

Versatile Cooler Models EZSTLG8L and

LZSTLG8L conguration as shipped

Versatile Cooler Models EZSTL8GL and

LZSTL8G8L alternate installation

INSTALLATION AND USE MANUAL

EZTL

™

& LZTL

™

Série versatile refroidisseurs d’eau à deux niveaux

EZTL

™

& LZTL

™

Serie versátil bi-nivel enfriadores de agua

EZTL

™

& LZTL

™

Series Versatile Bi-Level Water Coolers

Manual de instalación y uso

Manuel d’installation et utilisation

Summary of content (8 pages)

PAGE 1
EZSTLG8*1A, LZSTLG8*1A, INSTALLATION AND USE MANUAL Manual de instalación y uso Manuel d’installation et utilisation EZTL™ & LZTL™ Series Versatile Bi-Level Water Coolers EZTL™ & LZTL™ Serie versátil bi-nivel enfriadores de agua EZTL™ & LZTL™ Série versatile refroidisseurs d’eau à deux niveaux Versatile Cooler Models EZSTLG8L and LZSTLG8L configuration as shipped Versatile Cooler Models EZSTL8GL and LZSTL8G8L alternate installation PAGE 1 0000000558 (Rev.
PAGE 2
EZSTLG8*1A, LZSTLG8*1A, Note: Danger! Electric shock hazard. Disconnect power before servicing unit. Nota: peligro! Peligro de descarga eléctrica. Desconecte antes de reparar la unidad. Remarque : Danger ! Risque d'électrocution. Débrancher avant de réparer l'appareil.
PAGE 3
FIG.
PAGE 4
0000000558 (Rev. F - 01/19) E PAGE 4 7" 178mm 7/8" 22mm 2" 51mm B ‰ 2" 51mm F D ALT.
PAGE 5
EZSTLG8*1A, LZSTLG8*1A, HANGER BRACKETS & TRAP INSTALLATION 1) Remove hanger brackets fastened to back of cooler by removing one (1) screw. 2) Mount the hanger bracket as shown in Figure 2 or 3. NOTE: Hanger Brackets MUST be supported securely. Add fixture support carrier if wall will not provide adequate support. Anchor hangers securely to wall using all six (6) 1/4 in. dia. mounting holes. IMPORTANT: 1-7/16 in. (37mm) dimension from wall to centerline of trap must be maintained for proper fit.
PAGE 6
EZSTLG8*1A, LZSTLG8*1A, Service Instructions Lower and Upper Shroud To access the refrigeration system and plumbing connections, remove four screws from bottom of cooler to remove the lower shroud. To remove the upper shroud for access to the pushbars, regulator, solenoid valve or other components located in the top of the unit, remove lower shroud, disconnect drain, remove four screws from tabs along lower edge of upper shroud, unplug two wires and water tube.
PAGE 7
EZSTLG8*1A, LZSTLG8*1A, NOTE: When installing replacement bubbler and pedestal, tighten nut only to hold parts snug in position. Do Not Overtighten. NOTA: Al instalar el grifo y pedestal de reemplazo, apriete la tuerca unicamente para mantener las piezas en una posicion adjustada. No dede apretarse demasiado.
PAGE 8
EZSTLG8*1A, LZSTLG8*1A, 115V PARTS LIST/ 115V LISTA DE PIEZAS/ 115V LISTE DES PIÈCES ITEM NO. PART NO.