Installation

FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620

97696C (Rev. A - 1/01)

1. Remove mounting plate from packaging. Read this instruction sheet before proceeding.

These dimensions are required to obtain proper rim and bubbler heights for compliance with

ANSI standard A117.1.

2. Install plumbing rough-ins as per fountain instructions (supplied with fountain).

3. Install (2) 1/4” (6mm) screws (not provided) into wall at 43 5/8” above finished floor. Use the two best hole

locations for your application. Hang mounting plate on these screws and level mounting plate before tightening

screws.

4. Reinforce the wall in shaded areas for framed wall construction so that it will adequately support

the water fountain. This reinforcement must support up to 300 lbs static load and provide a means

for securing the mounting plate in place.

5. Attach mounting plate to finished wall surface with (12) 5/16” x 2” long bolts and flat washers, 6 per bracket

(not provided). Tighten securely. (Fastener must match wall type, i.e. lag screws for wood studs, bolts and

anchors for masonary construction.)

MP20 MOUNTING PLATE INSTRUCTIONS

PAGE 1
MP20 MOUNTING PLATE INSTRUCTIONS 1. Remove mounting plate from packaging. Read this instruction sheet before proceeding. These dimensions are required to obtain proper rim and bubbler heights for compliance with ANSI standard A117.1. 2. Install plumbing rough-ins as per fountain instructions (supplied with fountain). 3. Install (2) 1/4” (6mm) screws (not provided) into wall at 43 5/8” above finished floor. Use the two best hole locations for your application.
PAGE 2
MP20RA MOUNTING PLATE INSTRUCTIONS 1. Remove mounting plate from packaging. Read this instruction sheet before proceeding. These dimensions are required to obtain proper rim and bubbler heights for compliance with ANSI standard A117.1. 2. Install plumbing rough-ins as per fountain instructions (supplied with fountain). 3. Install (2) 1/4” (6mm) screws (not provided) into wall at 43 5/8” above finished floor. Use the two best hole locations for your application.