Installation Instructions

INSTALLING SINK
1. Position template on countertop. Locate the
template front to rear, so that sink will no t inter-
fere with the cabinet.
2. Trace a line around the template. Cut along the
inside of this line to provide opening. This size
ope ning wil l provide approximately a 1/2"
Reveal. (Please see item #2 under Attention
Installer.)
3. Locate and drill the mounting holes (following
the countertop manufacturer’s instructions) as
shown below. Holes should allow even spa
cing
of mounting brackets around the sink. Type of
fasteners to be as recommended by countertop
supplier.
4. Fasten mounting brackets to countertop loosely.
5. Using a good quality silicone caulk, apply a bead
evenly all around the t op of the sink flanges.
6. Position and align sink over the countertop
opening. Press silicone onto countertop.
7. Tighten fasteners until mounting bracket s are
snug against sink.
8. Check alignment of sink to countertop opening.
9. Tighten do
wn fasteners evenly. Be careful not to
overtighten. Remove excess silicone.
COUNTERTOP
MOUNTING
BRACKET
APPROX.1/2"
SILICONE CAULK
(NOT FURNISHED)
SINK
1-1/8"
(NOT FURNISHED)
PLAUH, PODUH, AND ELUHAD Series
Undermount Stainless Steel Sinks with
1/2” Reveal Countertop Installation
Installation Instructions
1) ELKAY RECOMMENDS THAT UNDERMOUNT SINKS SHOULD BE INSTALLED BY A PROFESSIONAL
EXPERIENCED INSTALLER.
2) WARNING: THE ENCLOSED CUTOUT TEMPLATE WILL CREATE A COUNTERTOP OPENING THAT
WILL EXPOSE APPROXIMATELY 1/2” OF SINK RIM LEDGE. IT IS RECOMMENDED THAT YOU DIS-
CUSS THIS WITH YOUR CUSTOMER AND AGREE THAT THIS FINISHED APPEARANCE IS THE
DESIRED EFFECT. ELKAY IS NOT RESPONSIBLE FOR IMPROPER SINK OR COUNTERTOP INSTAL-
LATIONS. DUE TO THE AESTHETIC QUALITIES OF THE CONVERGING BOWL RADII, THE TEMPLATE
FURNISHED WITH EACH SINK PROVIDES THE ONLY OPENING RECOMMENDED FOR INSTALLATION
OF ELKAY UNDERMOUNT SINKS. SEE ILLUSTRATION BELOW.
ATTENTION INSTALLER:
3) ELKAY UNDERMOUNT SINKS SHOULD ONLY BE FASTENED TO A SOLID SURFACE COUNTERTOP
(I.E. GRANITE/CORIAN /SILESTONE ).
®
®
4) ELKAY IS NOT REPONSIBLE FOR SINK OR COUNDTERTOP IF DAMAGED DURING INSTALLATIONS.
5) METAL EDGES MAY BE SHARP - USE CAUTION WHEN HANDLING.
6) FOLLOW ALL LOCAL PLUMBING AND BUILDING CODES.
7) INSPECT SINK FOR DAMGAGE PRIOR TO BEGINING INSTALLATION.

Summary of content (2 pages)