Installation Sheet

PAGE 6

4420BFFR_FTN_A LK4420BFFR_FTN_A

1000003686 (Rev. D - 03/20)

INSTRUCTIONS FOR CONNECTING TUBES FROM VALVE TO FOUNTAIN(S)

Step 1 - Insert the 1/8” O.D. tube(s) (Labeled A & B) into the connector(s) (provided with fountain). Insert the 1/8”

O.D. tube(s) coming from the fountain(s) push button actuator(s) into the connector(s). Trim any excess

length.

Step 2 - Secure the 1/8” O.D. tube(s) (Labeled C & D) to the waste line assembly. This line is a vent line and should

be open to the air.

Step 3 - Insert the 1/4” O.D. tube(s) (Labeled E & F) into the 1/4” union(s) (provided with valve assembly). Insert the

1/4” O.D. water lines coming from the fountain(s) into union(s). Trim any excess length.

Step 4 - Insert the 1/4” O.D. tube (Labeled G) into the air gap assembly.

Step 5 - Secure the 1/4” O.D. tube (Labeled H) to the waste line assembly. This line is a vent line and should be

open to the air.

LABEL A

(ON/OFF CONTROL LINE

FOR BUBBLER ONE)

LABEL F (WATER LINE)

LABEL G (DRAIN LINE)

LABEL E (WATER LINE)

LABEL B

(ON/OFF CONTROL LINE

FOR BUBBLER TWO)

LABEL C (VENT LINE)

LABEL H (VENT LINE)

LABEL D (VENT LINE)

FOUNTAIN CONNECTIONS

FIG. 4

FOUNTAIN CONNECTIONS

PLUMBING CONDUIT

(BY INSTALLER)

TO VALVE