Installation Sheet
PAGE 9
4420BFFR_FTN _A LK4420BFFR_FTN_A
1000003686 (Rev. D - 03/20)
1.Thisfountainistobemountedonasmooth,at,nishedsurfacewithadequatesupportstructure.NOTE:Mountingstructure
must be capable of supporting 300 lb. load on fountain.
2. Refer to rough-in for plumbing.
3.Installshut-ovalveonwatersupply.(Valvenotfurnished)
4. Locate and install fountain using 3/8" minimum fasteners. (Fasteners not furnished)
5.Priortoinstallingthebottlellertothecentermountingpositionoffountain,installthedrainpipe(Item#26)bypositioning
theshortendofdrainpipethroughmountingplateofbottleller.Next,placetheaestheticcollar(Item#42)ontothecenter
mounting position of the fountain ensuring the vertical edge of the collar is upright and the curved edge sits below the mount
ingsurface.Mountbottlellertofountainwithcollarcenteredbetweenthetwopieces.Securewithsuppliedhardware.
6.Priortoinstallingthebottlellertothearmmountoffountain,insertthedrainpipe(Item#27)intothearmtunnelandadjust
draintoleantotheleftsideofarmwhenfacingbutton.placetheaestheticcollar(Item#42)ontothearmmountingposition
of the fountain ensuring the vertical edge of the collar is upright and the curved edge sits below the mounting surface.
MountbottlellertoarmwithcollarcenteredbetweenthetwopiecesInstallbottlellertoarmbeingsuredraintubeis
abovemountingplateofller.Installllerontofountainandsecurewithsuppliedmountinghardware.
7. Connect water supply and fountain drain. Connect drain waste "Tee" to fountain drain tubes. Connect outlet of "Tee" to
drainagesystem.Connectfountainwaterlinetofreezevalvesupplylineasspeciedinabovesections.Waterconnection
and drain must comply with local codes.
8. Turn on water supply and check all connections for leaks.
INSTALLATION INSTRUCTIONS
IMPORTANT
ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON
IMPORTANT! INSTALLER PLEASE NOTE.
THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES
IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE
BUILDING. THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK INTO A FOUNTAIN, CREATING AN
ELECTROLYSIS WHICH CAUSES A METALLIC TASTE OR AN INCREASE IN THE METAL CONTENT OF THE
WATER. THIS CONDITION IS AVOIDABLE BY USING THE PROPER MATERIALS AS INDICATED. ANY DRAIN
FITTINGS PROVIDED BY THE INSTALLER SHOULD BE MADE OF PLASTIC TO ELECTRICALLY ISOLATE THE
FOUNTAIN FROM THE BUILDING PLUMBING SYSTEM.